Owner`s manual

ManualsBrandsR.H. Peterson ManualsDomestic AppliancesG4-12

L-A2-10208

Rev 3 - 0801151103

Important: Read these instructions carefully

before starting installation of the

burner control system.

Robert H. Peterson Co.

Robert H. Peterson Co. • 14724 East Proctor Avenue • City of Industry, California 91746

AUTOMATIC REMOTE CAPABLE SAFETY PILOT SYSTEM

FEATURES:

• NON-STANDING FLAME-SENSING PILOT •

• MANUAL SWITCH ON/OFF •

• OPTIONAL REMOTE CONTROL •

• BATTERY OPERATION •

(Suitable for G4, G45, and PB series burners)

(Sizes 12"- 24" for natural; 12"- 36" for propane gas)

PRE-ASSEMBLED

READY FOR INSTALLATION

EPK-1(M)(P) Installed

OWNER’S

MANUAL

RHP

The Peterson Real-Fyre

gas log set is to be installed

only in a solid-fuel-burning ﬁ replace with a working

ﬂ ue constructed of noncombustible material. Solid

fuels shall not be burned in a ﬁ replace where this

gas log set is installed. The installation, including

provisions for combustion, ventilation air, and required

minimum permanent vent opening, must conform with

the National Fuel Gas Code (ANSI Z223.1/NFPA 54)

and applicable local building codes. In Canada, the

installation must conform with the Natural Gas and

Propane Storage and Handling Installation Code

(CSA-B-149.1). A damper stop clamp is included

to maintain the minimum permanent vent opening

and to prevent full closure of the damper blade. The

chimney damper must be ﬁ xed fully opened when

burning this log set. This log set is designed to

burn with yellow ﬂ ames; thus, adequate ventilation

is absolutely necessary.

INSTALLER & CONSUMER

These instructions MUST be

retained with this appliance

MODEL EPK-1(M)(P)

Do not store or use gasoline or other

ﬂ ammable vapors and liquids in the vicinity

of this or any other appliance.

WHAT TO DO IF YOU SMELL GAS:

• Open a window.

• Do not try to light any appliance.

• Do not touch any electrical switch; do

not use any phone in the building.

• Immediately call the gas supplier from

a neighbor’s phone and follow the gas

supplier’s instructions.

• If you cannot reach the gas supplier,

call the ﬁ re department.

WARNING

If the information in this manual is not followed

exactly, a ﬁ re or explosion may result, causing

property damage, personal injury, or loss of life.

Installation and service must be

performed by an NFI Certiﬁ ed or other

qualiﬁ ed professional installer, service

agency, or the gas supplier.

Summary of content (10 pages)

PAGE 1
Robert H. Peterson Co.
PAGE 2
TABLE OF CONTENTS TABLE OF CONTENTS IMPORTANT INFORMATION EPK-1(P) PARTS LIST INSTALLATION ATTACHING THE EPK-1(P) VALVE TO THE BURNER INSTALLING THE FLAME DIVERTER BRACKET INSTALLING THE PILOT ASSEMBLY TO THE BURNER CONNECTING TO THE GAS SUPPLY CHECKING THE IGNITION PACK INSTALLING OR REPLACING BATTERIES FOR THE IGNITION MODULE PACK RADIANT HEAT SHIELD PLACEMENT PINE CONE PLACEMENT LIGHTING INSTRUCTIONS TROUBLESHOOTING THE EPK-1(M)(P) WARRANTY 2 2 3 4 4 4 5 5 6 7 7 7 8 9 10 IMPORTANT INFORMATION CHECK TO
PAGE 3
EPK-1(M)(P) PARTS LIST Note: Unit is shipped pre-assembled, ready for installation. DO NOT REMOVE THE PILOT ASSEMBLY FROM THE VALVE OR PINE CONE. Parts are shown below separated for identification purposes only. 4 Input pressure tap 1 12 Pilot gas line 2 8 Output pressure tap 6 ON/OFF Switch 13 5 7 9 Velcro strips 10 14 11 3 Remote kit (if equipped) and remote instructions Photos not to scale Item No. 1. or 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12. 13. 14.
PAGE 4
INSTALLATION HOW TO INSTALL THE EPK-1(M)(P) SAFETY PILOT SYSTEM This safety pilot system must be installed by a qualified professional installer. Instructions must be followed carefully when installing to ensure proper performance and full benefit from the gas log set and safety pilot system. These instructions must be used as a supplement to the instructions supplied with the Peterson gas log set.
PAGE 5
INSTALLATION (Cont.) Fig. 5-1 INSTALLING THE PILOT ASSEMBLY TO THE BURNER Caution: 1. Fasten bracket to burner pan Do not kink or damage the pilot supply tube, sparking, and sensor probes. Do not unscrew the gas line from the valve. 1. The pilot assembly comes with an L-shaped mounting bracket (Item #5). Using the two black screws (Item #6), fasten the bracket to burner pan (short side toward the back of the pan) using the pre-drilled holes in the pan (see Fig. 5-1). Fig.
PAGE 6
INSTALLATION (Cont.) CHECKING THE IGNITION PACK The EPK-1(M)(P) valve comes completely assembled with the wiring harness already connected to the pine cone switch assembly. However, we recommend that you follow the steps below to ensure it has not become detached during shipping before installing the batteries. Check TO CHECK THE WIRING ASSEMBLY Checkconnections connections 1. Check that the wiring harness is fitted tightly into the connector on the green ignitor pack in the rear of the pine cone (Fig.
PAGE 7
INSTALLATION (Cont.) INSTALLING OR REPLACING BATTERIES FOR THE IGNITION MODULE PACK Two 1.5-volt (D-cell) alkaline batteries come supplied with the EPK-1(M)(P). To install or replace batteries, remove the green ignition module pack (Item #3), held in place with a Velcro strip, from rear of the pine cone receiver (Item #9). Remove battery holder and, where installed, old batteries (Item #11) from the pine cone.
PAGE 8
LIGHTING INSTRUCTIONS We recommend that before you install the log set, you familiarize yourself with the control valve layout. This will help you to be confident operating the log set when fully installed. FOR YOUR SAFETY, READ BEFORE LIGHTING WARNING If you do not follow these instructions exactly, a fire or explosion may result, causing property damage, personal injury, or loss of life. The Real-Fyre® EPK-1(P) has a pilot that is lit using the ignitor switch.
PAGE 9
TROUBLESHOOTING THE EPK-1(M)(P) PROBLEM 1. Pilot will not light 2. No spark at pilot 3. Pilot lights, but main burner will not 4. Log set not bur ning properly CAUSE SOLUTION a. Obstruction in pilot gas supply or pilot gas-supply line is kinked a. Clear out obstruction. Replace pilot gassupply line if kinked b. Inadequate gas supply b. c. Air in line Have gas pressure checked by installer or gas supplier c. Air should clear; attempt to relight a. Loose wires a.
PAGE 10
FIRE MAGIC® OUTDOOR GAS GRILL LIMITED WARRANTY PLEASE COMPLETE AND RETURN YOUR REGISTRATION CARD, WHICH IS INCLUDED WITH YOUR FIRE MAGIC® GRILL LIFETIME WARRANTY - Fire Magic® cast stainless-steel burners, stainless-steel rod cooking grids, and stainless-steel housings are warranted for as long as you own your Fire Magic® grill.