Owner`s manual
7
L-A2-376
Rev 0 - 1312261320
This safety pilot system must be installed by a qualifi ed professional service technician. Instructions
must be followed carefully when installing to ensure proper performance and full benefi t from the
burner system and safety pilot system.
These instructions must be used as a supplement to the instructions supplied with the R.H. Peterson burner
system. Follow the burner system instructions and make adjustments as appropriate for the addition of a safety
pilot system. Use gas pipe sealing compound that is resistant to all gasses (or Tefl on tape) and apply to all
male pipe connections. Make sure that all connections are tight.
The valve system is shipped pre-assembled for easy
installation onto the burner pan. Perform installation with
care ensuring not to damage the pilot assembly, or the
wires that connect the components and heat shield.
Note: Installation is easier when done outside of the
fi replace.
PREPARATION
If the burner that the valve system is to be added to is
already installed; remove all decorative media, set aside to
be reinstalled later, and disconnect the fl ex connector and
adapter from the burner pan (using the instructions that
came with the original burner).
INSTALL PILOT MOUNTING BRACKET
The pilot assembly comes with an L-shaped mounting
bracket.Remove the two phillips screws holding the bracket
in place, then use them to fasten the bracket to burner pan
(short side toward the back of the pan) using the pre-drilled
holes in the pan (see Fig. 7-1).
INSTALL THE VALVE
1. Apply gas pipe sealing compound (or Tefl on tape) to the
male end of the fuel injector or air mixer on the burner.
2. Attach the adapter (pre-assembled to valve) to the fuel
injector or air mixer by screwing the pan into the adapter
(Fig. 7-2). Take care not to damage the attached pilot
assembly when rotating the burner pan. Be sure all
connections are tight.
Important: The rear of the valve may need to be angled
slightly upward to allow for the pan to sit fl at
against the fi replace fl oor. Adjust as necessary.
INSTALLATION
Fasten
bracket to
burner pan
Fig. 7-1
Burner pan
Fuel injector
or air mixer
Valve
Adapter
Attach the valve to the
air mixer/fuel injector by
rotating the burner pan.
Fig. 7-2
Install for 2V and
3V valves is the
same. 2V SHOWN.