Owner`s manual

L-A2-041

REV 7 - 1407290900

LIGHTING INSTRUCTIONS

If your gas log set is operated by the ﬁ replace valve:

1. Lay a lighted long-stem match on the surface of the embers near the gas inlet (do not hold the match

in your hand) or use a lighted long-necked butane lighter (Fig. 8-1).

2. Slowly turn the ﬁ replace remote valve to the ON position. Your log set should light.

3. If the log set does not light before the match goes out,

immediately turn the valve to the OFF position.

4. Wait approximately ﬁ ve (5) minutes to clear out any gas,

and repeat steps 1-3 above.

5. If your log set fails to light again, turn the valve to the OFF

position and contact your dealer or gas supplier.

6. To extinguish your gas log set, turn the valve to the

OFF position. Be sure the valve is turned fully off to avoid

any gas leakage.

If your burner is operated by a pilot kit:

1. Carefully follow the lighting instructions supplied with your

pilot kit for the steps to ignite the burner.

Before operating your gas log set:

1. Be sure your ﬁ replace is free from ﬂ ammable liquids or combustible materials.

2. Be sure your damper is open.

3. Smell all around the gas log set for the odor of escaping gas. IF YOU SMELL GAS, FOLLOW THE

INSTRUCTIONS ON P. 1.

Apply match - then turn on gas

To gas

supply

Match

Gas-supply

connection pipe

Fig. 8-1