Owner`s manual

4
REV 1 - 0711091249
No. L-A2-08107
CAUTION: Do not get granules into the pilot burner.
CAUTION: Do not kink the pilot supply tube or thermocouple.
GLOWING EMBER - G4, GX4, & VG4 SERIES FLAME PAN - P SERIES (PROPANE)
A. Attach the mounting bracket to the pilot
assembly with the screws provided (Item 7).
Note: Bracket and pilot assembly are shown
attached in above illustration.
B. Carefully bend the thermocouple lead and
the pilot gas supply line (Item 10) so the
pilot assembly is positioned as illustrated
above.
C. Place the insulating pad (Item 8) between
the bracket and the pan. Insert the screws
through the pilot bracket (Item 7) and the
holes in end of the pan.
A. Attach the mounting bracket with the screws
provided (Item 7) to the pilot assembly as located
above.
Note: Bracket and pilot assembly are shown
attached in above illustration.
B.
Carefully bend the thermocouple lead and
the pilot gas supply line (Item 10) so the pilot
assembly is positioned at end of the pan as
illustrated.
C. Place the insulating pad (Item 8) between the
bracket and the pan. Insert the screws through
the pilot bracket (Item 7) and the holes in end of
pan.
STEP 4: ATTACHING THE HEAT SHIELD TO THE SAFETY CONTROL VALVE
A. The heat shield is designed to protect the valve, knob, and extension
handle in both right and left-sided installations (see Fig. 4-1 and 4-2
below).
B. Place the heat shield on the valve with the middle key hole slot resting on
the extension handle. Slide the heat shield back so the middle key hole
slot locks onto the valve collar (where the extension handle attaches to
the valve) and the rear slot fi ts over the back of the valve (see Fig. 4-3).
L
0
F
F
O
N
PILOT
L
0
F
F
O
N
PILOT
Fig. 4-2
Fig. 4-1
Installation of SPK on left-hand-side of
the burner
Installation of SPK on right-hand-side
of the burner
Burner
pan
Flame diverter
bracket
Pilot assembly
Insulation
pad
Mounting
bracket
0
F
F
O
N
PIL
OT
L
MIDDLE KEY HOLE SLOT
Fig. 4-3
Middle key hole slot
Burner
pan
Pilot assembly
Mounting
bracket
Insulation pad
Flame diverter
bracket
STEP 3: INSTALL THE PILOT ASSEMBLY TO THE BURNER
Refer to the PARTS LIST when following these instructions.
HOW TO ASSEMBLE THE SAFETY PILOT KIT (Cont.)