Owner`s manual

5
REV 1 - 0711091249
No. L-A2-08107
SPK-26 OPERATING INSTRUCTIONS
Fig. 5-4
HOW TO LIGHT THE PILOT
To light the pilot from the PILOT position (Fig. 5-2),
push in slightly on the knob and turn to the OFF position
(Fig. 5-1). Wait fi ve minutes, then turn the knob to the
PILOT position (Fig. 5-2). Push the knob fully in and at
the same time place a long lighted match or long necked
lighter at the pilot burner. The pilot should light. Hold the
knob in approximately 60 seconds. If the pilot does not stay
lit, turn to the full OFF position (Fig. 5-1). Wait fi ve minutes
and repeat the LIGHTING INSTRUCTIONS.
HOW TO TURN THE GAS BURNER ON AND OFF
USING THE SAFETY PILOT KIT
BE SURE THE DAMPER IS FULLY OPEN WHEN
OPERATING THE GAS BURNER.
TO TURN ON THE GAS BURNER FROM THE PILOT
POSITION: When the pilot is lit (Fig. 5-2), turn the knob
90° counter-clockwise to the ON position (Fig. 5-3).
TO TURN OFF THE GAS BURNER FROM THE ON
POSITION (Fig. 5-3): Turn the knob 90° clockwise to
the PILOT position (Fig. 5-2).
TO TURN OFF THE GAS BURNER AND THE PILOT
FROM THE PILOT POSITION (Fig. 5-2): Push in slightly
on the knob and turn 90° clockwise to the OFF position
(Fig. 5-1).
PILOT ADJUSTMENT
Should the pilot require adjustment, the following steps
should be taken: With the pilot lit and the control knob in
the pilot position, use a long narrow screw driver and turn
the pilot adjustment screw slowly clockwise to reduce the
pilot fl ame or counter-clockwise to increase the fl ame (Fig.
5-4). The adjustment screw can be turned so that the
pilot fl ame is completely extinguished. Some tightening of
the screw may occur during adjustment; this is normal. The
pilot fl ame should be a soft blue color with slightly yellow
tipping which encircles the thermocouple tip.
Turn the control knob to the ON position to assure proper
ignition of the log burner.
Fig. 5-3
ON position
Burner on -
pilot on
Fig. 5-2
PILOT position
Burner off -
pilot on
Fig. 5-1
OFF position
Burner off - pilot off
Example
of burner
pilot fl ame
3. Turn knob to ON
to light burner.
1. Use OFF
only when complete
shutdown is necessary.
Read here
2. Turn dial to PILOT
position. With match ready,
press knob in and hold for 60
seconds while lighting pilot.
Read here
Read here
* We recommend that before you install the burner you familiarize yourself with the control valve layout. This will
help you to be confi dent operating the burner when fully installed (see fi gures below for typical control positions).
Pilot adjustment
FOR IMPROVED PILOT OPERATION