Owner`s manual

12
REV 4 - 0907131103
No. L-A2-01309
EMBER COALS PLACEMENT
Attach the ember bed (part No. CHD-01) to the burner
by slipping it onto the back edge (center left to right)
with the perforated section facing toward the back
fi replace wall (Fig. 12-1).
Cover the surface of the ember bed with the ember
coals (see Fig. 12-1a). For best glowing performance,
they should be applied evenly and pulled slightly apart
so the fi bers are somewhat loose. (It is not necessary
to pile the entire bag of the ember coals. More ember
coals may be added after completion of the entire
installation.)
These instructions must be used with the Charred Series gas log set - Charred Oak (CHD),
Charred Split (CHS), and Charred Royal (CHB).
CHARRED SERIES SUPPLEMENTAL INSTRUCTIONS
CHARRED SERIES LOG PLACEMENT
Place the long bottom rear log (Log #2) on the back of the grate with the fl at, hollow side facing the rear of
the fi replace. The two sections of the front log (Logs #1A & 1B) are placed on the front of the grate with the
charred sections facing each other and approximately 1" apart at the top (Fig. 12-2). There should be 3"
between the front and rear logs.
Place the two top knothole logs (Logs #3 & #4) so that one end rests on each front log (Logs #1A & 1B)
and the other end on the rear log (Log #2). The charred sections should be over the opening between the
front and rear logs (Fig. 12-3).
Place the small top charred log (Log #5) between the knothole logs so it rests on the rear log (Log #2) and
the right-hand front log (Log #1b) (Fig. 12-4) with the charred section facing the front.
Place the curved top charred log (Log #6) so the charred section rests on the left-hand front log (Log #1A)
and the other end rests on the middle of the right top knothole log (Log #4); see Fig. 12-5.
Place the additional top log (Log #7) on the top in the desired position. Additional log not available with the
18" log set.
Other options may be chosen for top log placement.
Light the log set, referring to installation instructions for procedures. More ember coals may be placed on
the ember bed for the added realism of a burning-wood look.
Fig. 12-2 Fig. 12-3
LOG #3
LOG #4
Fig. 12-4
LOG #5
Fig. 12-5
LOG #6
LOG #7
Note: Charred Oak (CHD) log set used for illustration.
Note: The ember bed is included with Charred
Series log sets only.
Fig. 12-1a
Fig. 12-1
Part No. CHD-01
LOG #1A
LOG #2
LOG #1B
3"
Ember bed