Owner`s manual

13
REV 4 - 0907131103
No. L-A2-01309
Before operating the gas log set:
1. Be sure the fi replace is free from fl ammable liquids
or combustible materials.
2. Be sure the damper is open.
3. Smell all around the gas log set for the odor of
escaping gas. If you smell gas:
a. Do not light the gas log set.
b. Do not touch any electrical switch.
c. Do not use the telephone in the building.
d. Call the gas supplier from a neighbor’s phone
and follow their instructions.
e. If you cannot reach the gas supplier, call the
fi re department.
LIGHTING INSTRUCTIONS
If the Real-Fyre
®
gas log set is operated by
the fi replace valve or the Peterson ON/OFF
system (AV series):
1. Lay a lighted long-stem match on the surface of
the embers near the gas inlet (do not hold the
match in your hand) or use a lighted long-necked
butane lighter (Fig. 13-1).
2. Slowly turn the fi replace remote valve or the
Peterson AV valve to the ON position. The log set
should light.
3. If the log set does not light before the match
goes out, immediately turn the valve to the OFF
position.
4. Wait approximately fi ve (5) minutes to clear out
any gas, and repeat steps 1-3 above.
5. If the log set fails to light again, turn off the valve
and contact the dealer or gas supplier.
6. To extinguish the Real-Fyre
®
gas log set, simply
turn the valve to the OFF position. Be sure
the valve is turned fully off to avoid any gas
leakage.
If the Real-Fyre
®
gas log set is operated by
a Peterson manual safety pilot system (SPK
series):
1. Light the pilot following the instructions included
with the safety pilot system.
2. From the pilot position, turn the control valve
counterclockwise to the ON position (Fig. 13-2).
The gas log set should light.
3. If the gas log set fails to light, refer to the
TROUBLESHOOTING section of the Peterson
SPK instructions.
4. To extinguish the Real-Fyre
®
gas log set, turn the
SPK control knob clockwise to the PILOT position.
The log set will extinguish, and the pilot will remain
lit.
5. To extinguish the pilot, from the PILOT position,
push the SPK knob in slightly and turn clockwise
to the OFF position.
GAS LOG SET OPERATING INSTRUCTIONS
Fig. 13-1
Fig. 13-2
ON OFF
ON PILOT OFF
We recommend that before you install the log set, you familiarize yourself with the control valve layout.
This will help you to be confi dent operating the log set when fully installed (see fi gures below for typical
control positions).