Owner`s manual

REV 4 - 0907131103

No. L-A2-01309

INSTALLING THE DAMPER CLAMP

Fig. 5-1

Damper clamp

INSTALLING THE BURNER SYSTEM

A damper clamp (Item #8) is provided as a means

to prevent full and/or accidental closure of the

ﬁ replace damper when installed as illustrated

(Fig. 5-1). When the gas log set is operating,

the damper must be fully open. To install the

damper clamp:

1. Open the ﬁ replace damper.

2. Place the damper clamp over the damper blade

(Fig. 5-1).

3. Tighten the set screw of the damper clamp

with pliers or a wrench so that it afﬁ xes to the

damper blade. The clamp must be permanently

installed.

4. Should the damper clamp not ﬁ t, install a

permanent damper stop or provide some other

means of preventing full and/or accidental

closure of the damper.

Open

Closed

Refer to the PARTS LIST section when installing the Real-Fyre

gas log set.

1. Carefully unpack the burner system. Check the PARTS LIST to be sure all parts are included.

2. The Real-Fyre

gas log set may be operated using a number of optional Peterson control

systems (see below), or with the remote gas valve of the ﬁ replace. Peterson control systems

are engineered to provide convenient, safe, and reliable operation of the gas log set.

For safe operation, proper performance, and to comply with safety standards and certiﬁ cations,

use only Robert H. Peterson Company control systems, parts, and accessories with the Real-

Fyre

gas log set.

Unpack the Peterson control system (if purchased) and check PARTS LIST provided with the control

to be sure all parts are included.