Owner`s manual

2
L-A2-00706
REV 1-1005110932
CHECK TO BE SURE THAT THE SAFETY PILOT HAS BEEN ASSEMBLED FOR THE PROPER GAS.
(Reference FOR PROPANE GAS section on page 3.)
The installation, including provisions for combustion
and ventilation air, must conform with local codes, or,
in the absence of local codes, with the National Fuel
Gas Code, ANSI Z223.1 (latest edition).
This appliance and its individual shutoff valve must
be disconnected from the gas supply piping system
when testing at pressures that exceed
1
/
2
psig. This
is accomplished by closing the gas supply line valve.
This appliance must be isolated from the gas supply
piping system by closing its individual manual shutoff
valve during any testing of the gas supply system at
test pressures up to and including
1
/
2
psig.
WHEN GLASS FIREPLACE ENCLOSURES
(DOORS) ARE USED, OPERATE THE GAS LOG
SET WITH THE GLASS DOORS OPEN; BOTH
SIDES IF FIREPLACE IS SEE-THRU TYPE.
Item No. Part No. Description
1. PAC-1 NAT Pilot assembly, complete
or
PAC-1 LP
2. SH-1 Flame diverter bracket
3. SV-12 Safety control valve
4. SPK-20 knob
5. EH-2 Extension handle
6. HS-9 Heatshield
7. EH-1 SPK-21 extension handle
IMPORTANT INFORMATION
PARTS LIST
2
1
3
4
5
6
SPK-20/P
7
SPK-21/P