Owner`s manual

ManualsBrandsR.H. Peterson ManualsLawn and GardenG45 Series

L-A2-20707REV 5 - 0705071310

Robert H. Peterson Co.

RHP

ROBERT H. PETERSON CO. • 14724 East Proctor Avenue • City of Industry, CA 91746

The burner system is to be installed only in a solid-

fuel-burning ﬁ replace with a working ﬂ ue constructed

of noncombustible material. Solid fuels shall not be

burned in a ﬁ replace where this gas log set is installed.

The installation, including provisions for combustion,

ventilation air, and required minimum permanent vent

opening, must conform with the National Fuel Gas Code

( ANSI Z223.1/NFPA 54) and applicable local building

codes. A damper stop clamp is included to maintain

the minimum permanent vent opening and to prevent

full closure of the damper blade. The chimney damper

MUST be fully opened when burning the log set. Your

log set is designed to burn with yellow ﬂ ames; thus,

adequate ventilation is absolutely necessary.

G45 SERIES TRIPLE-T BURNER

INSTALLER & CONSUMER

These instructions MUST be

retained with this appliance.

Important: To comply with certification,

listings, and building codes, and

for safe operation and proper

performance, only Peterson parts

and accessories MUST be used

with this gas log set.

Owner’s

Manual

Important: Read these instructions carefully

before starting installation of the

log set.

- Do not store or use gasoline or other

ﬂ ammable vapors and liquids in the

vicinity of this or any other appliance.

WHAT TO DO IF YOU SMELL GAS

• Open a window.

• Do not try to light any appliance.

• Do not touch any electrical switch; do not

use any phone in your building.

• Immediately call the gas supplier from a

neighbor’s phone. Follow the gas

supplier’s instructions.

• If you cannot reach the gas supplier,

call the ﬁ re department.

- Installation and service must be performed

by a qualiﬁ ed professional installer, service

agency, or the gas supplier.

WARNING: If the information in this

manual is not followed exactly, a ﬁ re or

explosion may result, causing property

damage, personal injury, or loss of life.

GLOWING EMBER

GAS LOG SET

Design Certiﬁ ed

ANSI Z21.84b 2004

Summary of content (14 pages)

PAGE 1
Robert H. Peterson Co. RHP Owner’s Manual ® Design Certified to GLOWING EMBER GAS LOG SET ANSI Z21.84b 2004 G45 SERIES TRIPLE-T BURNER WARNING: If the information in this manual is not followed exactly, a fire or explosion may result, causing property damage, personal injury, or loss of life. - Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance. WHAT TO DO IF YOU SMELL GAS • Open a window. • Do not try to light any appliance.
PAGE 2
TABLE OF CONTENTS PARTS LIST IMPORTANT INFORMATION FIREPLACE REQUIREMENTS PRE-INSTALLATION REQUIREMENTS INSTALLATION INSTALLATION (Continued) PLACEMENT OF GRANULES, GLOWING EMBERS, STABILIZER CLIPS, & GRATE LOG PLACEMENT OPTIONAL CHARRED SERIES INSTALLATION LIGHTING INSTRUCTIONS IMPORTANT OPERATING INFORMATION MAINTENANCE & SERVICE OPTIONAL CONTROLS OPTIONAL PETERSON VALVES & SAFETY PILOT KITS* TROUBLESHOOTING YOUR GAS LOG SET TROUBLESHOOTING YOUR GAS LOG SET (Continued) WARRANTY Tools Recommended Availab
PAGE 3
PARTS LIST Before installation, check that your gas burner system is complete. See the parts list below. If any parts are missing or damaged, contact your Real-Fyre® dealer. Various log styles are available for the G45 Triple-T burner system (see previous page) and are sold separately. Be sure you know the model and size of your set when ordering logs, options, or replacement parts and accessories. 5 1 6 7 4 8 Connector kit 8A 2 8B 3 ITEM No. 1. 2. 3. 4. 5. 6. or 7. 8.
PAGE 4
IMPORTANT INFORMATION Important: To comply with certification, listings, and building code acceptances, and for safe operation and proper performance of this log set, use ONLY Peterson Real-Fyre® parts and accessories. Use of other controls, parts, and accessories that are not designed for use with Real-Fyre® gas log sets is prohibited and will void all warranties, certifications, listings, and building code approvals, and may cause property damage, personal injury, or loss of life.
PAGE 5
INSTALLATION This gas log set must be installed by an NFI Certified or other qualified installer. The installation, including provisions for combustion and ventilation air, must conform with local codes, or in the absence of local codes, with the latest edition of the National Fuel Gas Code (ANSI Z223.1/NFPA 54). TO INSTALL THE GAS LOG SET, THE FOLLOWING STEPS MUST BE FOLLOWED. 1. A damper clamp (Item #7) is supplied and must be installed on the damper assembly as shown (Fig. 5-1). a.
PAGE 6
INSTALLATION (Continued) 6. Connect the elbows with tubing supplied (Item #8B). DO NOT kink tubing. Tighten both ends securely. Connect both elbows with tubing On gas supply stub On burner pan Fig. 6-1 Connector installed 7. Position the burner pan in the center of the fireplace. Do not push up against the rear fireplace wall. 8. LEAK TESTING Carefully turn on the gas supply, ignite the burner pan and leak test at all connections with a soapy water solution (equal parts liquid detergent and water).
PAGE 7
LOG PLACEMENT NOTE: LOGS SUPPLIED SEPARATELY. Log placement is very important for the proper operation of the Real-Fyre® gas log set. Although you have some flexibility in the log arrangement, it is necessary to follow the LOG PLACEMENT instructions carefully to fully enjoy your log set. Follow the steps below, referring Rear bottom to Fig. 7-1 through Fig. 7-5. Front Stabilizer log bottom Back wall clips 1.
PAGE 8
OPTIONAL CHARRED SERIES INSTALLATION GLOWING EMBERS PLACEMENT Note: Optional Charred Series log sets are supplied with an ember screen (Fig. 8-1). Fig. 8-1 Attach the ember screen to the burner by slipping it onto the back edge (center left to right) with the perforated section facing toward the back fireplace wall (Fig. 8-1). Cover the surface of the ember screen with the Glowing Embers (Fig. 8-2).
PAGE 9
LIGHTING INSTRUCTIONS Before operating your gas log set: 1. Be sure your fireplace is free from flammable liquids or combustible materials. 2. Be sure your damper is open. 3. Smell all around the gas log set for the odor of escaping gas. IF YOU SMELL GAS, FOLLOW THE INSTRUCTIONS ON P. 1. If your gas log set is operated by the fireplace valve: 1.
PAGE 10
MAINTENANCE & SERVICE Maintenance Once installed and operating properly, your Real-Fyre® gas log set will require regular maintenance. You should inspect your log set and controls (where installed) for the following: 1. Excessive sooting - Some sooting of your log set is normal, adding to the appearance of burned wood. If excessive sooting accumulates, clean the logs using any of the following options: Option 1. Spray the logs with clean water when they are being burned and hot.
PAGE 11
OPTIONAL PETERSON VALVES & SAFETY PILOT KITS* Note: For all valves and safety pilot kits shown on this page, carefully follow the instructions supplied with the safety pilot kit for steps to assemble and install it on the burner pan and test for leaks.
PAGE 12
TROUBLESHOOTING YOUR GAS LOG SET SYMPTOM 1. Excessive smoking and sooting 2. Low flame REV 5 - 0705071310 CAUSE SOLUTION A. Poor draft or downdraft A. Check for chimney blockage. Be sure chimney is at least 3' taller than anything within 10' of it in all directions. If not, consult a chimney sweep. Chimney cap or fan may help. Under severe conditions, you may need to open a window near the fireplace about 1" to 2" when burning the log set. B. Improper burner for gas used B.
PAGE 13
TROUBLESHOOTING YOUR GAS LOG SET (Continued) SYMPTOM 3. Uneven flame distribution. (Lower at one end of the burner) 4. Flame at air mixer (For propane units) REV 5 - 0705071310 CAUSE SOLUTION A. Clogged or blocked portholes A. Portholes can be cleared of foreign object by running a wire through them. B. Insufficient gas pressure and/or supply B. Consult installer or plumber. (See solution 2b.) C. Granules may be packed down too tightly C.
PAGE 14
WARRANTY PETERSON VENTED GAS LOG SETS LIMITED WARRANTY All Peterson gas logs are WARRANTED for as long as you own them (lifetime). All Peterson burner assemblies are WARRANTED for TEN (10) YEARS. SPK-26 controls are covered by a THREE (3) YEAR “All Parts” Warranty. All other Peterson valves, pilots, and controls are covered by a ONE (1) YEAR Limited Warranty (excluding batteries).