Owner`s manual

ManualsBrandsR.H. Peterson ManualsLawn and GardenG45 Series

Robert H. Peterson Co. • 14724 East Proctor Avenue • City of Industry, CA 91746

Owner’s

Manual

Important: Read this manual carefully before starting installation of the log set.

CODE AND SUPPLY REQUIREMENTS

The installation and the provisions for combustion

and ventilation air must conform with local codes and

ordinances, or in the absence of local codes, with the

latest National Fuel Gas Code, ANSI Z223.1/NFPA 54,

the Natural Gas and Propane Installation Code, CSA

B149.1, or International Fuel Gas Code.

Regulated burner

system for use with

propane or natural gas

INSTALLER: Leave this manual with the appliance.

CONSUMER: Retain this manual for future reference.

This appliance is designed as an attended

appliance. Adults must be present when the

unit is operating. DO NOT leave this unit burning

when unattended. If this product is left burning

unattended it may cause damage or serious

injury.

WARNING

Improper installation, adjustment, alteration,

service, or maintenance can cause injury or

property damage. Read the installation, operating

and maintenance instructions thoroughly before

installing or servicing this equipment.

The installation of appliances designed for manufactured

home (U.S. only) or mobile home installation must

conform with the Standard CAN/CSA Z240 MH, Mobile

Housing, in Canada, or with the Manufactured Home

Construction and Safety Standard, Title 24 CFR, Part

3280, in the United States, or when such a standard

is not applicable, ANSI/NCSBCS A225.1/NFPA 501A,

Manufactured Home Installations Standard.

Do not store or use gasoline or other

ﬂ ammable vapors and liquids in the vicinity

of this or any other appliance.

An LP-cylinder shall not be stored in the

vicinity of this or any other appliance.

WHAT TO DO IF YOU SMELL GAS:

• Do not try to light any appliance.

• Do not touch any electrical switch; do

not use any phone in the building.

• Immediately call the gas supplier from

a neighbor’s phone and follow the gas

supplier’s instructions.

• If you cannot reach the gas supplier,

call the ﬁ re department.

WARNING

If the information in this manual is not followed

exactly, a ﬁ re or explosion may result, causing

property damage, personal injury, or loss of life.

Installation and service must be performed

by an NFI Certiﬁ ed or other qualiﬁ ed

professional installer, service agency, or

the gas supplier.

11-020

FOR INSTALLATION IN

SOLID-FUEL BURNING

FIREPLACES

REV 0 - 1407291335

L-A2-293

G45 STAINLESS STEEL BURNER FOR INDOOR OR OUTDOOR USE

Burner systems:

G45-16/19(N,P)A-SS

G45-18/20(N,P)A-SS

G45-24(N,P)A-SS

G45-30(N,P)A-SS

G45-36(N,P)A-SS

DESIGN CERTIFIED

ANSI Z21.60-2012

CSA 2.26-2012

ANSI Z21.97-2012

CSA 2.41-2012

CAN/CGA-2.17-M87

Summary of content (16 pages)

PAGE 1
Owner’s Manual Burner systems: DESIGN CERTIFIED to G45-16/19(N,P)A-SS G45-18/20(N,P)A-SS G45-24(N,P)A-SS G45-30(N,P)A-SS G45-36(N,P)A-SS ANSI Z21.60-2012 CSA 2.26-2012 ANSI Z21.97-2012 CSA 2.41-2012 CAN/CGA-2.17-M87 FOR INSTALLATION IN SOLID-FUEL BURNING FIREPLACES Regulated burner system for use with propane or natural gas G45 STAINLESS STEEL BURNER FOR INDOOR OR OUTDOOR USE Important: Read this manual carefully before starting installation of the log set.
PAGE 2
Manuel du propriétaire Systèmes de brûleur: Certifié à: G45-16/19(N,P)A-SS G45-18/20(N,P)A-SS G45-24(N,P)A-SS G45-30(N,P)A-SS G45-36(N,P)A-SS ANSI Z21.60-2012 CSA 2.26-2012 ANSI Z21.97-2012 CSA 2.41-2012 CAN/CGA-2.
PAGE 3
TABLE OF CONTENTS SAFETY INFORMATION PARTS LIST BEFORE YOU BEGIN - IMPORTANT INFORMATION INSTALLATION INSTALLING THE BURNER GRANULE, EMBER, AND GRATE PLACEMENT LOG PLACEMENT OPTIONAL CHARRED SERIES INSTALLATION NOTES PAGE OPERATING THE LOG SET - LIGHTING AND EXTINGUISHING TECHNICAL DATA AND SPECIFICATION INFORMATION TROUBLESHOOTING THE GAS LOG SET WARRANTY 3 4 5 6 6 7 7 9 10 11 13 14 16 SAFETY INFORMATION 1.
PAGE 4
PARTS LIST Before beginning installation, be sure the gas log set is complete by comparing its contents with this PARTS LIST. The Golden Oak log set is listed and illustrated. The parts may differ depending upon the log style and size of the set. Be sure you know the model number and size of your set when ordering replacement or optional parts and accessories. 9 6 4 Replacement parts can be ordered from your local dealer. 10 Glowing embers 5 3 2 11 Granules 1 12 7 13 8 ITEM# DESCRIPTION 1.
PAGE 5
BEFORE YOU BEGIN - IMPORTANT INFORMATION Before You Begin, review the information and safeguards below about the installation and operation of the Real-Fyre® gas log set. Fig. 5-1 Fireplace dimensions Check to be sure that the fireplace meets the venting and construction requirements for the installation of the Real-Fyre® gas log set. Rear width THIS BURNER IS DESIGNED FOR USE WITH PROPANE OR NATURAL GAS.
PAGE 6
INSTALLATION The damper clamp with hex bolt (Fig. 6-1) is provided as a means to prevent full closure of the damper blade. The clamp is easily attached to most damper blades with pliers or a wrench, and must be permanently installed. The clamp is designed to prevent accidental closure of the damper when installed as illustrated (Fig. 6-2 and Fig. 6-3).
PAGE 7
INSTALLATION (cont.) 8. Be sure gas to the fireplace is off. Attach the large adapter end of the flex connector (Item 9) to the gas-supply stub using a pipe compound resistant to all gases. Ensure adapter (and nut) are tightened securely. Ensure the pan rests level on the fireplace floor after connection. Adjust the pan if necessary. Burner pan Fig. 7-1 Heat shield (removed) Thermocouple (under screen) Ignitor 9.
PAGE 8
LOG PLACEMENT (cont.) NOTE: LOGS SUPPLIED SEPARATELY. Log placement is very important for the proper operation of the Real-Fyre® gas log set. Although you have some flexibility in the log arrangement, it is necessary to follow the LOG PLACEMENT instructions carefully to fully enjoy your log set. Follow the steps below, referring Rear bottom to Fig. 8-1 through Fig. 8-5. Front Stabilizer log bottom Back wall clips 1.
PAGE 9
OPTIONAL CHARRED SERIES INSTALLATION GLOWING EMBERS PLACEMENT Note: Optional Charred Series log sets are supplied with an ember screen (Fig. 9-1). Fig. 9-1 Attach the ember screen to the burner by slipping it onto the back edge (center left to right) with the perforated section facing toward the back fireplace wall (Fig. 9-1). Cover the surface of the ember screen with the Glowing Embers (Fig. 9-2).
PAGE 10
NOTES PAGE Please use this page to record any information about your burner system that you may want to have at hand.
PAGE 11
OPERATING THE LOG SET - LIGHTING AND EXTINGUISHING FOR YOUR SAFETY, READ BEFORE LIGHTING WARNING: If you do not follow these instructions exactly, a fire or explosion may result, causing property damage, personal injury, or loss of life. A. BEFORE LIGHTING, smell all around the gas log set area for gas. Be sure to smell next to the floor because some gas is heavier than air and will settle on the floor. B. IF YOU SMELL GAS: • Shut off the gas to the appliance. • Extinguish any open flame.
PAGE 12
ACTIONNANT LA NOTATION RÉGLÉE - ÉCLAIRAGE ET S'ÉTEIGNANT POUR VOTRE SÛRETÉ, LISEZ AVANT L'ALLUMAGE AVERTISSEMENT: Si vous ne suivez pas ces instructions exactement, une incendie ou une explosion peut résulter, entraînant des dégats matériels, le dommage corporel, ou des pertes humaines. A. AVANT L'ALLUMAGE, sentez tous autour du secteur réglé de notation de gaz pour le gaz. Soyez sûr de sentir à côté du plancher parce qu'un certain gaz est plus lourd que l'air et arrangerez sur le plancher. B.
PAGE 13
TECHNICAL DATA AND SPECIFICATION INFORMATION MAINTENANCE SERVICE Once installed and operating properly, the RealFyre® gas log set requires very little maintenance. You should inspect the log set and control annually for the following: 1. Excessive sooting - Some sooting of the log set is normal and adds to the appearance of burned wood. If sooting accumulates, you may brush the soot off with a stiff brush. Do not use water or soot cleaners to clean off the soot.
PAGE 14
TROUBLESHOOTING THE GAS LOG SET SYMPTOM 1. Excessive smoking and sooting CAUSE A. Poor draft or down draft Note: Like burning natural firewood, the RealFyre® gas log set is designed to burn with a yellow smoky flame. Some sooting is common and desirable. B. Improper set for gas used C. Damper closed D. Set is positioned too close to the front of the firebox E. Improper log placement 2. Low flame F. Air mixer on propane set is closed A. Incorrect log set size for burner system B.
PAGE 15
TROUBLESHOOTING THE GAS LOG SET (cont.) SYMPTOM 3. Uneven flame distribution (Lower at one end of the burner) 4. Flame backing out of air mixer (propane) REV 0 - 1407291335 CAUSE A. Clogged or blocked portholes A. B. Insufficient gas pressure and/or supply C. Granules may be packed down too tightly or not evenly B. D. Auxiliary shut-off valve partially closed D. E. Valve not fully open A. Clogged or blocked portholes E. A. B. Insufficient gas pressure and/or supply C.
PAGE 16
WARRANTY PETERSON VENTED DECORATIVE GAS APPLIANCE LIMITED WARRANTY Robert H. Peterson Co. ("RHP") warrants your Real Fyre® vented decorative gas appliance to be free from defects in material and workmanship. Peterson vented ceramic refractory gas logs are warranted for as long as you own them (lifetime). Peterson vented burner assemblies are WARRANTED for TEN (10) YEARS. Peterson vented outdoor stainless-steel burner assemblies are warranted for FIVE (5) YEARS.