Owner`s manual

7
L-A2-256
Rev 6 - 1501210930
FLAME
DIVERTER
BRACKET
BURNER
PA N
2 1/2
REAR WALL
Burner pan
Flame
diverter
bracket
1-
1
/4"
INSTALLATION (Cont.)
INSTALL FLAME DIVERTER BRACKET
For installation on G4/G45 burners only. When properly
installed onto the burner pan, the fl ame diverter bracket
will promote quicker ignition and protect the safety control
system from overheating.
Note: You must fi rst install the fl ame diverter bracket
before installing the pilot/igniter assembly.
1. Place the fl ame diverter bracket over the side edge
of the burner pan, near the location the safety control
system pilot bracket will be attached. It should be
placed approximately 1-
1
/
4
" from the rear wall of
the burner pan (see Fig. 7-1).
2. Tap the bracket lightly with a rubber mallet to secure
it in place.
INSTALL PILOT ASSEMBLY TO BURNER
CAUTION: Use only the pilot assembly pre-assembled
with this kit. Never substitute with an existing
pilot.
CAUTION: Do not kink or damage the pilot supply line
and thermocouple tube. Do not unscrew the
gas line from the valve.
1. The pilot assembly comes with two Phillips screws
installed on the long side of the pilot bracket. Remove
the screws and use them to fasten the pilot assembly
to the burner pan using the pre-drilled holes in the
pan (see Fig. 7-2 and Fig. 7-3).
Note: Ensure the insulation is properly in place between
the pilot bracket, burner pan, and pilot assembly.
Screw from the inside of burner pan.
2. Ensure the pilot supply line and thermocouple tube
are bent in a similar manner as shown in Fig. 7-3 to
prevent damage / unsafe operation, and to allow for
proper heat shield placement. Maintain this orientation
at all times.
WARNING: Keep the pilot assembly clear at all
times. Never cover any part of the pilot
assembly.
Fig. 7-1 Install diverter bracket (if applicable)
Fig. 7-3 Proper line and tube orientation
Fasten pilot
assembly to
burner pan
Fig. 7-2 Install pilot assembly
(screw from
inside)
Properly bend
line and tube