Owner`s manual

9
L-A2-256
Rev 6 - 1501210930
INSTALLATION (Cont.)
CONNECT REMOTE RECEIVER (if equipped)
Note: Discard the black wires that come with the remote
receiver.
1. Install the provided batteries in the remote transmitter
and receiver.
2. Place the receiver as far from the burner system as
possible (see Fig. 9-1).
Note: Place the receiver a minimum of 6" from the
burner/fl ame.
3. Place the plastic cover over the remote receiver
with the open side facing front to allow access to the
receiver controls (see Fig. 9-1).
4. Ensure the remote receiver wire harness is properly
connected to the valve as shown in Fig. 9-2.
HEAT SHIELD PLACEMENT
TO PREVENT VALVE DAMAGE AND FAILURE:
IT IS CRITICAL THAT THE HEAT SHIELD BE
PLACED CORRECTLY OVER THE VALVE PRIOR
TO OPERATION.
TO PREVENT OVERHEATING THE VALVE:
Cover the valve with the heat shield as shown in Fig. 9-3
and Fig. 9-4. It should rest fl at above the valve.
Keep the area above and below the heat shield clear
of decorative media or any other objects at all times.
Important: Ensure the pilot supply line and
thermocouple tube do not interfere with
heat shield placement.
Important: Keep sand granules, lava granules, and all
foreign objects away from the pilot assembly,
valve assembly, and heat shield during
media placement and at all times.
APK-17 installation is complete at this point. Ensure ALL
information in this manual is followed to ensure proper
operation.
DECORATIVE MEDIA REPLACEMENT
Refer to the burner instructions for proper placement of
decorative media.
Important: Keep sand granules, lava granules, and all
foreign objects away from the pilot assembly,
valve assembly, and heat shield during
media placement and at all times.
Fig. 9-3 Place heat shield
Fig. 9-4 Heat shield properly placed
(from
remote
receiver)
Ensure connection
Wire
harness
Fig. 9-2 Ensure harness connection
Valve
HEAT SHIELD
MUST BE
PROPERLY
PLACED
Fig. 9-1 Place receiver away from burner
6" min.
Receiver
(w/ plastic cover)