Owner`s manual

5
(Refer to the PARTS LIST when following these instructions)
RADIANT HEATSHIELD PLACEMENT
Cover the safety valve (Item 2) with the radiant
heatshield (Item 1). Be sure the solid black face of the
shield is between the valve and the burner.
MOUNTING THE PILOT ASSEMBLY TO THE
PETERSON REAL-FYRE
®
BURNER
1. ATTACHING THE FLAME DIVERTER
BRACKET ON THE BURNER
Attach the fl ame diverter bracket (Item 3) to the
side wall of the burner pan nearest to the valve.
The fl ame diverter bracket should be placed
approximately 1
1
/
4
" from the back side of the
burner pan.
Note: The fl ame diverter bracket is used only on
G4, GX4, VG4, and P series burners.
2. GLOWING EMBER BURNER - G4, GX4, AND
VG4 SERIES
a. Attach the pilot assembly mounting bracket
(Item 7) to the pilot assembly (Item 5) with #10
screws (Item 6) (Fig. 4-1).
Note: Bracket, insulation pad and pilot assembly
are shown attached.
b. Place the burner insulation pad (Item 8)
between the bracket and the burner. Insert the
screws (Item 6) through the pilot assembly,
insulation pad, and holes in the side of the
burner, and tighten.
3. PAN BURNER — P SERIES
a. Attach the pilot assembly mounting bracket
(Item 7) to the pilot assembly (Item 5) with #10
screws (Item 6), as shown in Fig. 4-2.
Note: Bracket, insulation pad, and pilot assembly
are shown attached.
b. Place the burner insulation pad (Item 8)
between the bracket and the burner. Insert
the screws (Item 6) through the pilot assembly,
insulation pad, and holes in the side of the
burner.
Note: The APK-11(M)(P) is compatible with all Peterson remote control options. Contact your Peterson
dealer for more information.
Note: The generator and gas supply leads should
not be touching the burner pan or be placed
in the fi re.
CHECK ALL CONNECTIONS FOR GAS LEAKS
USING A SOAPY WATER SOLUTION. NEVER
USE AN OPEN FLAME TO CHECK FOR GAS
LEAKS.
CK-4 Connector tube
Hearth
elbow
INSTALLATION INSTRUCTIONS (cont.)
Fig. 5-2
Mounting
bracket
Insulation
pad
Burner
pan
Flame diverter
bracket
Pilot
assembly
Fig. 5-1
Pilot
assembly
Mounting
bracket
Insulation
pad
Burner
pan
Flame
diverter
bracket