Owner`s manual

6
HOW TO TURN THE GAS LOG SET ON AND OFF
USING THE APK SYSTEM
To turn on the gas log set with the pilot lit, turn the
safety valve knob to the ON position. Switch the toggle
switch control to the ON (up) position and the gas log
set will light.
To turn off the gas log set, switch the toggle switch
control to the OFF (down) position. The pilot will remain
lit.
To turn off the pilot, be sure the toggle switch control
is OFF, and depress and turn the safety valve knob to
the OFF position.
For remote lighting; follow the instructions for lighting
the pilot above and then follow the instructions that
came with your remote.
MAINTENANCE OF THE APK SYSTEM
The log set is equipped with a safety pilot that will shut
off the gas supply in case the pilot is not burning or
functioning properly. Make sure the pilot is adjusted
properly and that the generator spade clips are tightly
connected to the terminal screws on the valve. If the
pilot will not stay lit, call the local gas utility or gas
supplier.
A periodic check of the following should be performed
at least annually by a qualifi ed, professional service
representative:
1. Valves and toggle switch control for proper
operation.
2. Flue system for rust, damage, or leaks.
3. Damper operation.
4. Orifi ces for dirt or other foreign matter.
5. Visual check on the burner.
HOW TO LIGHT THE PILOT
To light the pilot from the PILOT position, push in
slightly on the safety valve knob and turn to the OFF
position. Wait fi ve minutes, then turn the safety valve
knob to the PILOT position. Push the safety valve knob
fully in and at the same time place a long match or a
butane lighter at the pilot burner. The pilot will light. Hold
the safety valve knob in for approximately 60 seconds.
If the pilot does not stay lit, turn the safety valve knob
to the full OFF position. Wait fi ve minutes and repeat
the LIGHTING INSTRUCTIONS.
PILOT ADJUSTMENT
A. The pilot fl ame should encircle the generator tip,
which is preset at the factory (Fig. 2-1). Ordinarily,
the pilot will not require fi eld adjustment.
B. If adjustment is necessary, remove the cap screw
and turn the smaller gas adjustment screw inside
counter-clockwise to increase the pilot fl ame and
clockwise to decrease the pilot fl ame. Replace cap
screw. Refer to Fig. 3-1, page 3.
OPERATING INSTRUCTIONS
Pilot
Generator
Lighting the pilot
Pilot fl ame should encircle top of the generator
Fig. 6-1