Manual

ManualsBrandsR&M Materials Handling ManualsHoistELECTRIC CHAIN HOISTS LoadMate Chain Hoist LM 10

LM10 I&M MANUAL/EN/11.30.2010

40/85

This document and the information contained herein, is the exclusive property of R&M Materials Handling, Inc., and represents a non-public, confidential and proprietary trade secret

that may not be reproduced, disclosed to third parties, altered or otherwise employed in any manner whatsoever without the express written consent of R&M Materials Handling, Inc.

7.10.3 Top Hook

Figure 22. Top Hook Orientation

CAUTION: Before removing Top Hook, de-energize the power to the hoist per ANSI Z244.1

and make certain that any load is removed from the load hook. Also support the total

weight of the hoist, including chain, prior to removing the Top Hook.

Removing Top Hook

1. Place hoist on workbench. Protect limit switches on bottom side of hoist.

2. Remove screw and locking plate.

3. Pull pins out and remove hook.

CAUTION: Proper installation of top hook is critical for hoist balance.

Installing Top Hook

1. Place hoist on workbench. Protect limit switches on bottom side of hoist.

2. Determine number of chain falls: 1-fall or 2-fall. Reference Figure 22.

3. Select proper placement of top hook relative to number of chain falls:



If 1-fall, align top hook so that tip of hook faces toward chain container.



If 2-fall, align top hook so that tip of hook faces away from chain container.

4. Place hook into the slot on hoist body. Verify that top hook saddle and load hook saddle are in line with

each other. Install pins and locking plate. Secure locking plate with screw.

CHAIN

CONTAINER

BRACKET