Service Manual

R&M Materials Handling, Inc.
4501 Gateway Boulevard
Springfield, Ohio 45502
P.: [phone]
FAX: (937) 325
-
5319
6/53
R&M Materials Handling, I
nc. reserves the right to alter or amend the above information without notice.
1.7 Terminology
The following terms and definitions may have been used in this manual:
ANSI American National Standards Institute
Authorized personnel Persons who are authorized by the owner and who have the necessary training to carry out operation or
service actions.
CE marking The product’s CE-marking indicates that the product complies with the appropriate CE regulations.
Check A visual and functional assessment (not a test) of the product without dismantling.
Current rating The maximum flow of current through a frequency converter.
Bridge The bridge (main girder) moves along the runway.
Main girder The main girder (bridge) is connected to the bridge end carriages.
Main isolation switch The main isolation switch is the power switch which the operator should normally use to turn off the power.
Hoist Drive mechanism for lifting and lowering the load.
Power supply Power is supplied to the components via the power supply.
Controller The pendant or other type of controller is used by the operator to give commands to the crane.
Qualified personnel One with necessary qualification based on theoretical and practical knowledge of hoists or/and cranes. The
person must be in a position to assess the safety of the installation in conjunction with the application. Persons
with the authority to undertake certain maintenance work on products of manufacturers include manufacturers’
service engineers and trained fitters with corresponding certification.
QR Code™ A two dimensional bar code that can include, for example, a product’s serial number in an optically readable
form.
Note: The term “QR Code” is a registered trademark of Denso Wave Incorporated in Japan and other
countries.