Service Manual

R&M Materials Handling, Inc.
4501 Gateway Boulevard
Springfield, Ohio 45502
P.: [phone]
FAX: (937) 325
-
5319
7/53
R&M Materials Handling, Inc. reserves the right to alter or amend the above information without notice.
1.8 Directives and standards
1.8.1 CE/CSA/UL/CCC
This product complies with one or more of the following requirements and directives described in this section. For
more detailed information about which requirements the product meets, see the main sticker attached to the
device.
CE The CE marking certifies that a product has met EU health, safety, and environmental requirements, which ensure consumer
safety.
CSA The CSA marking means that a product has been tested and meets applicable standards for safety and/or performance,
including the applicable standards written or administered by the American National Standards Institute (ANSI), Underwriters
Laboratories (UL), Canadian Standards Association (CSA), National Sanitation Foundation (NSF), and others.
UL The UL marking means that Underwriters Laboratories (UL) has tested representative samples of the product and
determined that they meet UL's requirements. These requirements are based primarily on UL's published and nationally
recognized Standards for Safety.
CCC The China Compulsory Certificate mark, commonly known as the CCC Mark, is a compulsory safety mark for a variety of
products sold on the Chinese market. The CCC mark is required for both domestically manufactured products and products
imported into China.
RoHS The RoHS marking means that a product complies with the directive for the restriction of the use of certain hazardous
substances in electrical and electronic equipment.
WEEE The WEEE indicates that the product should be disposed of according to the WEEE directive regulations.
The frequency converters carry the CE label as a proof of compliance with the Low Voltage Directive (LVD) and the
Electro Magnetic Compatibility (EMC). The company SGS Fimko has acted as the Competent Body.
1.8.2 EMC
The abbreviation "EMC" stands for Electromagnetic Compatibility. According to the European EMC directive, "the
apparatus shall be so constructed that:
 The electromagnetic disturbance it generates does not exceed a level allowing other apparatus to operate as
intended
 The apparatus has an adequate level of intrinsic immunity of electromagnetic disturbance to enable it to
operate as intended".
Declaration of conformity With the declaration of conformity the manufacturer informs that a device is manufactured to fulfil
required EMC standards.
Environments Immunity and emission requirements are divided in two levels in the product standard according to
the environments.
First environment is an environment that includes
domestic premises and other establishments
directly connected to a low-voltage power supply
network.