Troubleshooting guide

maintenance / SpeciFicationS

precauTions

1) Please take care in the handling of this precision device. If the unit is dropped or subjected to extreme shock, the calibration

may be thrown off. Calibration problems due to abuse, or droppage may affect the warranty.

2) DO NOT expose the XGC-1e to water. It utilizes a ventilated enclosure to properly “sample” the CO

specificaTions:

System operating voltage 120vac +/- 20% @ 50-60 Hertz

Maximum Switching amperage 15-amps @ 120vac

Overload protection 15-amp normal blow fuse

Operating temperature 30-120º F

Maximum humidity 95% RH (Non-condensing)

Temperature control range 50-115º F with a 7º F differential, +/- 3.6º

Humidity control range 20 - 80% RH with a 5% differential

Adjustable timer repeatability +/- .5% under fixed conditions

Timer setting accuracy +/- 10%

Hydro “ON” timer 30 seconds to 20 minutes

Hydro “OFF” timer 12 minutes to 480 minutes

24-hour timeclock accuracy +/- 3% monthly

Operating principle Fuzzy Logic™, w / Single-beam Non-Dispersive Infrared (NDIR)

Measurement range 0 – 5000 PPM CO

Warm-up time Minimum 10 minutes (full accuracy)

Maximum drift per year +/- 15 PPM

Accuracy @ 77’F +/- 5% of reading

Repeatability < 1% of Fixed Scale

Calibration interval Three years

sensor Operating life expectancy 15 years typical

Dimensions 10” X 8” X 7”

Weight Less than 6 lbs.

Relay operations Minimum 100,000 electrical / 10,000,000 mechanical

mainTenance:

1) Consult the troubleshooting chart for a listing of the most common problems.

2) DO NOT open the enclosure!!! There are no components that require maintenance.

3) Do not use this equipment for purposes other than what it is designed for. It will provide many years of trouble-free service when

used properly.

4) In the event you cannot solve the problem, first consult the dealer who sold the unit then contact the factory for instructions on

how to return it to the factory for repair.

Published By R & M Supply Inc.

Liability statement:

R & M Supply and their retailers and distributors are not responsible for any damage or injuries (consequential or otherwise) arising

from the use of this device. The purchaser assumes all responsibility for the use and proper installation of this device.