Specifications

8
Connections for MIG INV160
Setup machine as per two diagrams below:
Fig 1 Fig 2
1. Earth / Workpiece connector
Connect the earth lead (negative - ) to this connector.
Insert male connector into socket and twist clockwise until tight.
Secure other end of earth lead to Workpiece via the earth clamp.
2. Euro torch connector
Connect Euro type Mig torch to euro torch connector, align torch connector to machine
connector and then turn retaining ring clockwise to secure.
Ensure torch is secured tightly to avoid weld power problems
To avoid electric shock keep the Mig torch in good condition and replace if any of the
insulation is damaged.
3. Mains input cable
Fit required plug as per your electrical installation
4. Gas inlet connection
Connect gas hose to rear of machine and then to regulator on gas bottle. Ensure all
connections are tight to ensure no loss of gas.
Make sure gas bottle is secured to machine securely using supplied chain to avoid
injury.
5. On/Off Power Switch
This turns the INV160 Mig Welder on and off.