User's Manual

PTRL-LCD & RXRL-LCD

ELETTRONICA

13 / 36

User Manual

Rev. 2.3 - 26/06/19

Connect the audio cable and RDS/SCA of the signal source to the proper input

connectors of the PTRL-LCD.

Note: RF EXPOSURE SAFETY DISTANCE (only for FCC & IC)

RF Exposure Limits for United States of America, according to FCC regulation:

etting to the maximum of the output power of the apparatus, to guarantee

the limits of exposure declared within this document, it is necessary that

the antenna gain used with this device should be 0dBi or less and all

persons should maintain a minimum separation distance of 45.51cm for

general uncontrolled exposure and general controlled exposure.

RF Exposure Limits for Canada, according to IC regulation: setting to the

maximum of the output power of the apparatus, to guarantee the limits of

exposure declared within this document, it is necessary that the antenna

gain used with this device should be 0dBi or less and all persons should

maintain a minimum separation distance of 53.12 cm for general uncontrolled

exposure and general controlled exposure.

Limites d’exposition RF: en réglant au maximum de la puissance de sortie de

l’appareil, afin de garantir les limites d’exposition déclarées dans ce document, il

est nécessaire que le gain d’antenne utilisé avec cet appareil doit être de 0 dBi

ou moins et toutes les personnes doivent conserver une distance de séparation

minimale de 53.12 cm pour les expositions générales non contrôlées et les

expositions générales contrôlées.

5.2 Operation

Switch on the transmitter by putting the selector on the position “I” (on) the switch

situated on the panel, and switch it on thanks to the switch situated on the front

panel.

Enter the menu “Set” and set the working frequency desired.

With the help of the switches and trimmers situated on the rear pannel, set the

characteristics (impedance, preenphasis, and possibly stereo/mono) and the levels

of the audio inputs and RDS (if used).

Note: When it comes out of the factory, the output power of the unit is regulated

at the minimum and is setted on the OFF position. Anyway we always advise to

check the setted level before you select the output power, especially when the

unit is used as modulator of a power amplifier.

From the predefined menu, set the desired power level (from 1 W to full-scale).