User's Manual

20 / 36
User Manual
Rev. 2.3 - 26/06/19
PTRL-LCD & RXRL-LCD
ELETTRONICA
6. RXRL-LCD quick guide for installation and use
This chapter contains the necessary instructions for the installation and use of the
equipment. In case some aspects are not totally clear, for instance when a user
is using this equipment for the first time, we advise the new user to read carefully
the entire description contained in this manual.
6.1 Preparation
Unpack the receiver and before doing any other operation, be sure it has not
been damaged during transport. In particular check that all the connectors are in
perfect condition.
The main fuse can be accessed from the outside on the rear panel. Extract the
fuse carrier with a screwdriver to check its integrity or for replacement, if necessary.
The fuse to be used is this type:
• MAIN FUSE 1.6 A 5x20
Check that the supply voltage value coincides with the AC voltage available.
The input supply field is of:
• RXRL-LCD 80-260 V
AC
Check that the switches of the RXRL-LCD are in the position “0” (off).
The RXRL-LCD has a switch which interrupts completely the AC supply of the
unit.
Connect the RF output of the exciter to the antenna cable .
Connect the AC cable to the corresponding VDE socket.
Note: It is essential that the AC network has an accurrate grounding system in
order to ensure both the safety of the users and the correct functioning of the
unit.
If the user intends to use external batteries in case of AC supply interruption,
connect them to the clamps situated at the back of the equipment being careful
to respect the polarity.
WARNING: Keep in mind that the general switch of the transmitter has an effect
on the AC supply, and not on the possible auxiliary supply. If you use an external
supply with continuous current, it is then necessary to have an external switch for
this purpose.
Connect the audio cables of your own audio signal to the apropriate connectors
situated at the back of the exciter.