User's Manual

8 / 54
User Manual
Rev. 2.1 - 26/06/19
TEX1002LCD
4.5.3 I
2
C Bus
Type: Male DB9
1 NC
2 TX_D
3 RX_D
4 Internally connected to 6
5 GND
6 Internally connected to 4
7 Internally connected to 8
8 Internally connected to 7
9 NC
4.5.4 Left (MONO) / Right
Type: Female XLR
1 GND
2 Positive
3 Negative
4.5.5 Remote
Type: Female DB15
Pin Name Type Purpose
1 Interlock IN Inhibits power if closed to
GND
2 Ext AGC FWD IN Ext. signal,1-12V, for limitation
(AGC)
3 GND Ground
4 SDA IIC I/O Serial data for IIC communication
5 VPA Tlm ANL OUT PA supply voltage: 3.9V
F.S.
6 FWD Tlm ANL OUT Forward power: 3.9V F.S.
7 Power Good DIG OUT Indicates activation by
switching the normally-open contact
to ground (sect. 5.4.1).
8 GND Ground
9 GND Ground
10 Ext AGC RFL IN Ext. signal,1-12V, for limitation
(AGC)
11 SCL IIC I/O Clock for IIC communication
12 IPA Tlm ANL OUT PA supply current: 3.9V
F.S.
13 RFL Tlm ANL OUT Reflected power: 3.9V F.S.
14 On cmd DIG IN A pulse towards ground (500 ms)
triggers power output
15 OFF cmd DIG IN A pulse towards ground (500 ms)
inhibits power output.