User's Manual

16 / 36
User Manual
Rev. 2.0 - 26/06/19
TEX100LCD/S
ELETTRONICA
capable of dissipating the power generated by the amplifier. To begin with, set
exciter to minimum output power and switch if off.
Connect the amplifier INTERLOCK OUT output to the matching INTERLOCK IN
input fitted on all R.V.R. Elettronica exciters as standard; if your exciter is a different
brand, identify an equivalent input.
Connect the RF output to an adequately rated dummy load or to the antenna.
Figure 5.1: Connections with exciter
WARNING: To avoid electrical shock and electrocution, never touch the RF
output connector when the equipment is switched on and no dummy load
is connected.
Ensure that the POWER switch on the front panel of TEX100LCD/S is set to
“OFF”.
The exciter has two switches: one is embedded in VDE socket for mains power
cord and interrupts all mains power supply of the machine, while the second is on
the front panel and acts by inhibiting the switching power supply of the machine.
Connect the mains power cable to the MAINS connector on the rear panel.
Note: the mains must be equipped with adequate earth connection properly
connected to the equipment. This is a pre-requisite for ensuring operator safety
and correct operation.
Connect the audio and RDS/SCA signals from user’s sources to the transmitter
input connectors.
Note: RF EXPOSURE SAFETY DISTANCE (only for FCC & IC)
RF Exposure Limits for United States of America, according to FCC regulation:
setting to the maximum of the output power of the apparatus, to guarantee
the limits of exposure declared within this document, it is necessary that
the antenna gain used with this device should be 0dBi or less and all