User's Manual

TEX100LCD/S
ELETTRONICA
17 / 36
User Manual
Rev. 2.0 - 26/06/19
persons should maintain a minimum separation distance of 199.47 cm for
general uncontrolled exposure and general controlled exposure.
RF Exposure Limits for Canada, according to IC regulation: setting to the
maximum of the output power of the apparatus, to guarantee the limits of
exposure declared within this document, it is necessary that the antenna
gain used with this device should be 0dBi or less and all persons should
maintain a minimum separation distance of 248.27 cm for general uncontrolled
exposure and general controlled exposure.
Limites d’exposition RF: en réglant au maximum de la puissance de sortie de
l’appareil, afin de garantir les limites d’exposition déclarées dans ce document, il
est nécessaire que le gain d’antenne utilisé avec cet appareil doit être de 0 dBi
ou moins et toutes les personnes doivent conserver une distance de séparation
minimale de 248.27 cm pour les expositions générales non contrôlées et les
expositions générales contrôlées.
5.1.5 First power-on and setup
Perform this procedure upon first power-up and each time you make changes to
the configuration of the transmitter this component is integrated into.
Note : Standard factory settings are RF output power off (Pwr OFF) and regulated
output power set to upper limit (unless otherwise specified by customer).
5.1.5.1 Power-on
When you have performed all of the connections described in the previous
paragraph, power on the exciter using the suitable power switch on the front
panel.
5.1.5.2 Power check
Ensure that the ON LED turns on. Equipment name should appear briefly on the
display, followed by forward power and modulation readings. If the RF output is
disabled, those readings will be zero.
When the PLL locks to operating frequency, the LOCK LED will turn on.
5.1.5.3 How to enable the RF output
Check output power level and set it to maximum level (unless it has already been
set) from the Power Setup menu that you will have accessed by pressing the
following sequence of key: ESC (opens Default Menu) ⇒ ENTER (hold down for
2 seconds) ⇒ SET ⇒ use keys to set bar to upper limit.
Check the state of the Pwr output power by the Fnc menu. If it is set to OFF, press
ENTER to bring the selection to ON.