User's Manual

26 / 36

User Manual

Rev. 2.0 - 26/06/19

TEX100LCD/S

ELETTRONICA

Menu 8

F1 Operating frequency setup. Set a new frequency value and then press the

ENTER button to confirm your selection; the exciter unlocks from current

frequency (the LOCK LED turns off) and will lock to the new operating

frequency (LOCK

turns back on again).

If you press ESC or let the preset time time out, the previous frequency

setting is retained.

5.3.5 Miscellaneous Menu (Mix)

This menu lets you set equipment address in an I

C bus serial connection:

Menu 9

IIC I

C address setting. The I2C network address becomes significant when

the exciter is connected in an RVR transmission system that uses this

protocol. Do not change it unless strictly required.

PSW Setting a numeric password of 4 characters.

At the time of purchase, the password is set to [0000] by default; this

configuration automatically disables the entry of the password in default

screen.

NOTE: It is advisable to write down the password set, if you forget the

password it is not possible to recover it automatically. To recover the

password, contact Customer Service by sending the alphanumeric PUK code

of 6 characters generated automatically when entering the password.

5.3.6 Version Menu (Vrs)

This screen holds equipment version/release information::

Menu 10