User's Manual

28 / 36
User Manual
Rev. 2.0 - 26/06/19
TEX100LCD/S
ELETTRONICA
Menu 12
Press the ENTER key when FSK is highlighted in the selection menu to access
the FSK submenu:
Menu 13
FSK Enables / disables FSK code transmission.
Cod Shows the Morse code sent normally.
5.4.1.1 Changing the ID code
User may change the FSK code used as a station identifier at any time.
This procedure requires:
• 1 RS232 male-female cable;
• Hyper Terminal interface (make sure it has been installed together with
Windows®) or equivalent serial communication software.
A brief description of the procedure is provided below:
• Connect the PC serial port COM to the SERVICE connector on the rear panel
of TEX100LCD/S using a standard Male DB9 - Female DB9 serial cable.
• Power on the exciter;
• Launch the serial communication software;
• Set communication parameters as follows:
Baud Rate: 19200
Data Bit: 8
Parity: None
Stop Bit: 1
Flow control: None;
• Activate Caps-Lock through the communication software and send string CODE
followed by the 6-character station ID code followed by Enter.