User's Manual

10 / 36
User Manual
Rev. 2.0 - 26/06/19
TEX702LCD
ELETTRONICA
TEX702LCD
@ 90÷260 Vac
Mains fuses (1x) 8A tipo 5x20
Table 5.1: Fuses
5.1.2 Placement of equipment
Useful tips for a correct installation:
• Do not use in presence of external elements near inlets and outlets ventilation
systems, as they could prevent a proper ventilation of the device.
• Do not place near any source of heat or flammable gas.
• Avoid places subject to accumulation of humidity, dust, sand, salt or environments
that could compromise the correct operation of the equipment.
• Avoid installing the equipment into inhabited places due to possible noise
pollution or on fragile supports. The operation of the equipment can cause a
noise due to forced ventilation. The mounting surface must be able to withstand
the weight of the device and must be sturdy.
Note: below we will refer to a complete station, where the device can be a part of
it. The same procedures also apply in case of the device is used individually.
The device is usually connected inside a 19 “rack and fixed with M5 screws in the
appropriate holes.
The equipment must be installed at least 1 mt from the ground.
Install the rack in the point in which the transmitter will be put in operation. The
rack is mounted on wheels for easy movement so that, once placed in the desired
location, it is advisable to use the four screws located at the base of the rack to
stabilize it perpendicularly to ground.
The environment, where you have decided to install the rack, should be set up
for about 25°C of air conditioning and equipped with a filter to remove dust and
salt air.