User's Manual

26 / 36

User Manual

Rev. 2.0 - 26/06/19

TEX702LCD

ELETTRONICA

5.3.5 Miscellaneous Menu (Mix)

This menu lets you set equipment address in an I

C bus serial connection:

Menu 9

IIC I

C address setting. The I2C network address becomes significant when

the transmitter is connected in an RVR transmission system that uses

this protocol. Do not change it unless strictly required.

PSW Setting a numeric password of 4 characters.

At the time of purchase, the password is set to [0000] by default; this

configuration automatically disables the entry of the password in default

screen.

NOTE: It is advisable to write down the password set, if you forget the

password it is not possible to recover it automatically. To recover the

password, contact Customer Service by sending the alphanumeric PUK code

of 6 characters generated automatically when entering the password.

5.3.6 Version Menu (Vrs)

This screen holds equipment version/release information::

Menu 10

Note that these are readings, rather than settings, and cannot be edited (note the

empty arrow).

Rel Firmware release information.

Dat Release date.

Tab Shows table loaded in the memory.

5.3.7 Channels Menu (L&R)

Right and left channel input levels are displayed as horizontal bars as shown in

the figure below.