Specifications

Eurgle ESC-80A MANUALS 5page/pages
·After you click the ‘finish’ button, there will be an icon
‘Eurgle’ on your computer desktop.
·Installation complete.
Ⅷ How to connect the controller to PC
·Plug the receiver lead of ESC-80A into the Eurgle USB Linker, please pay attention to the polarity for correct
connection. (Seeing the label on the USB Linker) .
·Connect the USB Linker to one of available USB ports of your computer. A little red LED on USB Linker will
light up. At the same time, a green LED on the controller would light up when correctly connected, otherwise not
NOTE: These two destination folders are both default
and cannot be changed, otherwise the software cannot
work normally.
NOTE: The receiver lead of Eurgle controllers are consisted of three small colored wires and adopt JR wire con-
figuration, i.e, red (+), brown (-) and orange (signal)