Instruction Manual
INSTRUCTIONS
WP1LED™ INSTALLATION
RAB Lighting is committed to creating high-quality, affordable, well-designed and energy-efficient LED lighting and controls that make it easy for electricians to install
and end users to save energy. We’d love to hear your comments. Please call the Marketing Department at 888-RAB-1000 or email: marketing@rablighting.com
Fig: 1
Fig: 2
IMPORTANT
READ CAREFULLY BEFORE INSTALLING FIXTURE. RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE.
RAB fixtures must be wired in accordance with the National Electrical Code and all applicable local codes. Proper grounding is
required for safety. THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION CODE BY A PERSON
FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE HAZARDS INVOLVED.
WARNING: Make certain power is OFF before installing or maintaining fixture. No user serviceable parts inside.
CAUTION: For proper weatherproof function all gaskets must be seated properly and all screws inserted and tightened
firmly. Apply weatherproof silicone sealant around the edge of the ceiling mounting box and/or junction box. This is
especially important with an uneven ceiling surface. Silicone all plugs and unused conduit entries.
MOUNTING
Fixture should not be recessed. Mount fixture on a wall with lens
facing down as shown above. Use the Drill Template on the inside
back surface of the housing to match most standard junction
boxes or lag bolt housing to mounting surface using locations
noted below.
1. Open door by loosening (4) screws. Remove LED Board.
2. Prepare the housing for use by drilling out the appropriate holes.
3. Line up the housing in desired location and mount securely
using mounting bolts. Caulk bolts heads.
4. Complete the wiring to the supply wires and ground (see wiring
instructions).
5. Replace the LED Board. Close door and tighten the four screws.
WP1LED - Wall Pack
Lag Bolt Locations
Drill Template
Housing
LED board
Door Lens