User`s manual
User’s Manual 3
1.2 Development and Evaluation Tools
1.2.1 Tool Kit
A Tool Kit contains the hardware essentials you will need to use your OP7200. The items
in the Tool Kit and their use are as follows.
• OP7200 Getting Started instructions.
• Dynamic C CD-ROM, with complete product documentation on disk.
• Programming cable, used to connect your PC serial port to the OP7200.
• Universal AC adapter, 12 V DC, 1 A (includes Canada/Japan/U.S., Australia/N.Z.,
U.K., and European style plugs).
• Demonstration Board with pushbutton switches and LEDs. The Demonstration Board
can be hooked up to the OP7200 to demonstrate the I/O.
• Wire assembly to connect Demonstration Board to OP7200.
• Screwdriver.
• Rabbit 2000 Processor Easy Reference poster.
• Registration card.
Figure 1. OP7200 Tool Kit
PROG
DIAG
Programming
Cable
Screwdriver
Getting Started
Instructions
Demo Board
Rabbit and Dynamic C are registered trademarks of Digi International Inc.
eDisplay (OP7200)
The OP7200 intelligent operator interface is a small, high-performance, C-programmable data acquisition
and display unit that offers built-in I/O, Ethernet connectivity, and an optional touchscreen. These Getting
Started instructions included with the Tool Kit will help you get your OP7200 up and running so that you
can run the sample programs to explore its capabilities and develop your own applications.
Tool Kit Contents
The OP7200 Tool Kit contains the following items:
• Dynamic C CD-ROM, with complete product documentation on disk.
• Demonstration Board with pushbutton switches and LEDs.
• Wire assembly to connect Demonstration Board to OP7200.
•
Programming cable, used to connect your PC serial port to the OP7200.
• Universal AC adapter, 12 V DC, 1 A (includes Canada/Japan/U.S., Australia/N.Z., U.K., and European
style plugs).
• Screwdriver.
• Getting Started instructions.
• Rabbit 2000 Processor Easy Reference poster.
• Registration card.
Visit our online Rabbit store at www.rabbit.com/store/ for the latest information on peripherals and acces-
sories that are available for the OP7200 operator interface.
Step 1 — Install Dynamic C
®
Before doing any development, you must install Dynamic C. Insert the CD from the Tool Kit in your PC’s
CD-ROM drive. If the installa tion does not auto-start, run the setup.exe program in the root directory
of the Dynamic C CD. Install any Dynamic C modules after you install Dynamic C
.
Demo Board
Wire
·
B
U
Z
Z
E
R
·
L
E
D
4
·
L
E
D
3
·
L
E
D
2
·
L
E
D
1
·
K
·
+
5
V
·
S
W
4
·
S
W
3
·
S
W
2
·
S
W
1
·
G
N
D
BUZZER
H
1
J
1
H2
· · 1-2
· · 3-4
· · 5-6
LED1 LED2 LED3 LED4
SW1 SW2 SW3 SW4
·
·
8
-7
·
·
6
-5
·
·
4
-3
·
·
2
-1
DEMO BOARD
Universal
AC Adapter
with Plugs