Quick Reference Guide

race result AG Joseph-von-Fraunhofer-Straße 11, 76327 Pfinztal Germany
[phone] [e-mail]
Using the following will return nothing:
#301
#301PARTY
Other Barcode Types
Chip2Go machines can work with any type of 2D barcode (such as QR codes), but
the scanner and returned data must meet certain requirements. No official support is
given for third-party device uses or barcode setup.
Requirements:
• Scanner uses USB HID specification
• Barcode is in the format #1234~ as per the standard Barcode Format
• Data returned from the scanner is terminated with the enter key
USB Stick Chip File
From firmware version 1.0.0 the Chip2Go has the ability to read a chip file from a
USB drive, this file should be stored as a .txt file.
Within the file numbers can be entered in different ways, different methods should be
separated by a new line.
- Simple number entry e.g. 1
- Number range e.g. 1-100
- Comma separated numbers e.g. 1,2,3
To use the chip file simply insert the USB drive in to one of the ports of the Chip2Go
and press Switch Mode and select USB List File. This will then list the available .txt
files which you can select.
Once the file has been opened all numbers in the file will be listed in the same order
(some grouping may occur), so you can choose where in the list to start from in case
of continuing a range or with multiple machines running. The Chip2Go will then
encode all subsequent numbers in the file in the same order.
Transponder Check Antenna
The check antenna on the front side of the Chip2Go can be used to check the chip
code of any passive race result transponder.
Simply hold the transponder in front of the check antenna and the chip code will be
displayed at the bottom of the display.