User's Guide
Table Of Contents
- VBOX Indoor Positioning System User Guide
- 01 - VBOX IPS Introduction
- 02 - VBOX IPS Hardware Installation
- Rover (VIPS-R-V2) Installation
- 03 - VBOX IPS Rover Connection to VBOX 3i
- 04 - VBOX IPS Site Configuration
- Upload to Beacon
- 05 - VBOX IPS Using with a VBOX 3i/Standalone
- 06 - VBOX IPS Troubleshooting
- VBOX IPS - PIN OUTS
- VBOX IPS - Technical Specification
- VBOX IPS - Upgrading Firmware
- VBOX IPS - Regulatory Information
Using External IMU
Connection between the Rover and VBOX 3i is via the supplied RLCAB153 cable.
• Insert the 7 way Lemo connector in to the right hand connector on the Rover.
• Connect the 25 way connector to the A IN port on the VBOX 3i.
• Connect the 5 way Lemo connector to the SER port on the VBOX 3i.
• Insert the 6 way Lemo connector in to the left hand connector on the Rover.
• Insert the other end of the cable in to the CAN / KF port on the IMU04.
https://racelogic.support/01VBOX_Automotive/VBOX_Indoor_Positioning_System/VBOX_IPS_User_Guide/
10