User's Guide
Table Of Contents
- VBOX Indoor Positioning System User Guide
- 01 - VBOX IPS Introduction
- 02 - VBOX IPS Hardware Installation
- Rover (VIPS-R-V2) Installation
- 03 - VBOX IPS Rover Connection to VBOX 3i
- 04 - VBOX IPS Site Configuration
- Upload to Beacon
- 05 - VBOX IPS Using with a VBOX 3i/Standalone
- 06 - VBOX IPS Troubleshooting
- VBOX IPS - PIN OUTS
- VBOX IPS - Technical Specification
- VBOX IPS - Upgrading Firmware
- VBOX IPS - Regulatory Information
By selecting New, or a previously saved configuration file, you are then presented with options necessary for correct
VIPS operation.
Site Settings
The first page the user is presented with is the Site Settings tab. Here you can configure how the Rover is expected to
operate and also change the Radio Settings.
Note: The radio settings are for Racelogic development purposes only.
Identifier
There may be multiple VBOX IPS operating within the same test ground and so to ensure the rover only uses the
signals coming from the intended test site, a site identifier needs to be entered. This identifier will need to match the site
identifier of the beacons that will be used.
For temporary installations, this identifier should be set to 0. For permanent installations a non-zero number should be
used.
https://racelogic.support/01VBOX_Automotive/VBOX_Indoor_Positioning_System/VBOX_IPS_User_Guide/
12