User's Guide
Table Of Contents
- VBOX Indoor Positioning System User Guide
- 01 - VBOX IPS Introduction
- 02 - VBOX IPS Hardware Installation
- Rover (VIPS-R-V2) Installation
- 03 - VBOX IPS Rover Connection to VBOX 3i
- 04 - VBOX IPS Site Configuration
- Upload to Beacon
- 05 - VBOX IPS Using with a VBOX 3i/Standalone
- 06 - VBOX IPS Troubleshooting
- VBOX IPS - PIN OUTS
- VBOX IPS - Technical Specification
- VBOX IPS - Upgrading Firmware
- VBOX IPS - Regulatory Information
Load
The Load Button allows you to load the settings from previously surveyed installation.
Add
The Add Button allows you to add a new beacon into the system. Adding a new beacon will automatically increment the
‘Friendly ID’ by 1.
Delete
The Delete Button allows you to remove the selected beacon from the installation.
Note: There will be no negative effects of having beacons in the configuration that will not actually be present in the
physical installation.
Clear all
The Clear all button will remove all beacons in the list.
Friendly ID
The Friendly ID is a user friendly ID that should match the sticker on the Beacon. The Friendly ID cannot be changed
and will be a consecutive count up from 1.
https://racelogic.support/01VBOX_Automotive/VBOX_Indoor_Positioning_System/VBOX_IPS_User_Guide/
14