User's Guide
Table Of Contents
- VBOX Indoor Positioning System User Guide
- 01 - VBOX IPS Introduction
- 02 - VBOX IPS Hardware Installation
- Rover (VIPS-R-V2) Installation
- 03 - VBOX IPS Rover Connection to VBOX 3i
- 04 - VBOX IPS Site Configuration
- Upload to Beacon
- 05 - VBOX IPS Using with a VBOX 3i/Standalone
- 06 - VBOX IPS Troubleshooting
- VBOX IPS - PIN OUTS
- VBOX IPS - Technical Specification
- VBOX IPS - Upgrading Firmware
- VBOX IPS - Regulatory Information
Upload to Beacon
Once the site configuration has been entered correctly, the information is needed to be uploaded to the Rover. This can
be done via Bluetooth, however for the initial release it is recommended to use the supplied configuration cable.
To upload the configuration, a COM port will first need to be selected from the drop down list of available COM ports. If
the required COM port is not displayed, pressing the Refresh button will refresh the COM port list.
https://racelogic.support/01VBOX_Automotive/VBOX_Indoor_Positioning_System/VBOX_IPS_User_Guide/
16