User's Guide
Table Of Contents
- VBOX Indoor Positioning System User Guide
- 01 - VBOX IPS Introduction
- 02 - VBOX IPS Hardware Installation
- Rover (VIPS-R-V2) Installation
- 03 - VBOX IPS Rover Connection to VBOX 3i
- 04 - VBOX IPS Site Configuration
- Upload to Beacon
- 05 - VBOX IPS Using with a VBOX 3i/Standalone
- 06 - VBOX IPS Troubleshooting
- VBOX IPS - PIN OUTS
- VBOX IPS - Technical Specification
- VBOX IPS - Upgrading Firmware
- VBOX IPS - Regulatory Information
When uploading to a Rover once a COM port is selected, the user will need to Enter LPC mode. This is only required
once per power cycle. Once in ‘LPC Mode’ the user can then press the Upload button to upload the configuration to the
beacon. The software will then inform the user whether the upload has been successful or not.
When uploading to a Beacon there is no need to first enter LPC mode, the configuration can be uploaded directly.
https://racelogic.support/01VBOX_Automotive/VBOX_Indoor_Positioning_System/VBOX_IPS_User_Guide/
17