User's Guide
Table Of Contents
- VBOX Indoor Positioning System User Guide
- 01 - VBOX IPS Introduction
- 02 - VBOX IPS Hardware Installation
- Rover (VIPS-R-V2) Installation
- 03 - VBOX IPS Rover Connection to VBOX 3i
- 04 - VBOX IPS Site Configuration
- Upload to Beacon
- 05 - VBOX IPS Using with a VBOX 3i/Standalone
- 06 - VBOX IPS Troubleshooting
- VBOX IPS - PIN OUTS
- VBOX IPS - Technical Specification
- VBOX IPS - Upgrading Firmware
- VBOX IPS - Regulatory Information
Site Origin of 0
VBOX IPS normally outputs locations in degrees latitude and longitude, if however an origin of 0,0 is given, then the
conversion to latitude/longitude is skipped and the VBOX IPS rover will output in meters X,Y. When operating with a
VB3i, an origin is always needed, when operating in standalone mode, this is optional.
https://racelogic.support/01VBOX_Automotive/VBOX_Indoor_Positioning_System/VBOX_IPS_User_Guide/
19