User's Guide
Table Of Contents
- VBOX Indoor Positioning System User Guide
- 01 - VBOX IPS Introduction
- 02 - VBOX IPS Hardware Installation
- Rover (VIPS-R-V2) Installation
- 03 - VBOX IPS Rover Connection to VBOX 3i
- 04 - VBOX IPS Site Configuration
- Upload to Beacon
- 05 - VBOX IPS Using with a VBOX 3i/Standalone
- 06 - VBOX IPS Troubleshooting
- VBOX IPS - PIN OUTS
- VBOX IPS - Technical Specification
- VBOX IPS - Upgrading Firmware
- VBOX IPS - Regulatory Information
Rover (VIPS-R-V2) Installation
The VIPS Rover looks similar to the Beacon, however the rover contains an internal IMU and so care should be taken to
ensure that the Rover is mounted on a section of the roof that has the least vibration. This is usually towards the rear of
the vehicle, just in front of the rear windshield. The rover should also be mounted in a way such that it has a clear view
to the beacons and away from any objects that may block that view (Roof bars, radio antennas etc).
https://racelogic.support/01VBOX_Automotive/VBOX_Indoor_Positioning_System/VBOX_IPS_User_Guide/
7