SM ART SPRINKLER CONTROLLER G EN ER AT I O N 2 Let’s get started.
What’s in the box.
What you’ll need. Wi-Fi Access (2.4 GHz only) Phillips Screwdriver Smartphone or Tablet Hammer (Drywall Installs) Drill and Drill Bit (Drywall Installs) The Rachio Smart Sprinkler Controller, Generation 2, is designed for indoor installation. If outdoor installation is required, you’ll need our weather-resistant enclosure. Learn more at rachio.com/outdoors.
Need some help? Check out our Help Center. Give us a call. support.rachio.com 1 (833) 722 4462 Not sure what to do with your old controller? We’ll recycle it for free! Visit rachio.com/recycle.
STEP 1 Out with the old! Test your old system to ensure everything works properly. Photograph the wiring inside your existing controller to reference during installation. Remove your old controller from the wall.
STEP 2 Mark screw locations. Use the Mounting Template at the end of this guide to mark where you want to install your Generation 2. For Drywall Installation: Drill holes at marked locations for the anchors. Use a 3/16 inch bit to drill through the drywall, then use a hammer to gently tap each anchor into place.
STEP 3 In with the new! Remove the faceplate of the Generation 2. Mount your new controller by screwing it onto the wall using the provided screws.
Mounting Template Ensure the lower holes are level, and use a pencil to mark the center of each hole.
Tear here to detach the mounting template.
STEP 4 Connect your wires. While referencing the photo of your previous wiring, insert the wires into the appropriate terminals. Things not matching up? Visit rachio.com/wiring for tips on advanced wiring. BEST PRACTICE: WIRING Insert screwdriver tip into the rectangular wire terminal. Press in until the rectangular terminal is flush with the gray terminal bar or you feel a click. Insert your wire, then release the rectangular terminal.
C 1-16 Common Wires Zone Wires Common wires are often labeled “C” or “Com.” You can insert them into any of the “C” terminals. Zone wires correspond to your landscape’s zones. Insert them into the numbered terminals. M S1-2 SC SP Master Valve Sensor Wires (Optional) Not all systems have a master valve. Master valve wires are often labeled “M,” “MV,” or “Pump.” If you have a master valve, wire it into the “M” terminal.
STEP 5 Create an account. Find the Rachio app on the Apple App Store, on Google Play, or by visiting rachio.com/download. Once the app is installed, create your account.
STEP 6 Connect to Wi-Fi. Open the Rachio app and select “Add Controller.” The app will guide you through this process. Once your controller is online, all four blue lights will be solid. You can now replace the faceplate.
STEP 7 Complete setup on the app. Now that the controller is online, use the Rachio app to customize your zones and create a schedule.
Congrats, you did it! Want to learn more about what you can do with your new Generation 2? Control your system remotely. Integrate your smart home. Optimize your waterings. Visit rachio.com/more.
Manual Controls Zones can be run directly from the controller, if needed. Use the up and down arrows to highlight a zone on the controller’s lights, then press the select button.
