Instruction Manual

ManualsBrandsRacing Electronics ManualsAccessories communication2-WAY EQUIPMENT

WWW.RACINGELECTRONICS.COM

RACING ELECTRONICS | 840 DERITA ROAD | CONCORD, NC | 28027 | 1.800.272.7111

YOUR FREQUENCIES ARE:

Congratulations! You have just purchased the ﬁnest in race

communications equipment from the Leader in Professional

Race Communications. Please store this manual in a safe

place. It contains important information about the use of your

equipment.

2-WAY EQUIPMENT

INSTALLATION,

OPERATION &

MAINTENANCE

YOUR #1 SOURCE FOR PROFESSIONAL

RACE COMMUNICATIONS... WORLDWIDE

Summary of content (6 pages)

PAGE 1
YOUR #1 SOURCE FOR PROFESSIONAL RACE COMMUNICATIONS... WORLDWIDE 2-WAY EQUIPMENT INSTALLATION, OPERATION & MAINTENANCE Congratulations! You have just purchased the ﬁnest in race communications equipment from the Leader in Professional Race Communications. Please store this manual in a safe place. It contains important information about the use of your equipment. YOUR FREQUENCIES ARE: WWW.RACINGELECTRONICS.COM RACING ELECTRONICS | 840 DERITA ROAD | CONCORD, NC | 28027 | 1.800.272.
PAGE 2
FULL FACE HELMET INSTALLATION: 1) Remove the helmet’s inside padding on the right side. 2) Position the Mic-Boom so that the vents in the Mic will touch your lips, but swing away and towards the front snout of the helmet when putting it on and taking it off. 3) Mount RT605, RT615, RT705 and RT715 Helmet Kits by attaching the cable clamp around the middle section of the ﬂex boom. Use a rivet to secure the clamp.
PAGE 3
OPEN FACE HELMET INSTALLATION: 1) Remove the helmets’s inside padding on the right side. 2) Drill a 5/16” hole in the right side of the helmet positioned so that mic will touch the driver’s lips when the boom is installed. 3) Remove the bottom screw and ﬁrst plastic washer from the Boom Support. 4) Insert the screw and plastic washer from the inside and attach to the boom support on the outside of the helmet. Do not fully tighten yet. 5) Remove the screw, knurled knob and washer.
PAGE 4
CAR INSTALLATION: Antenna: For best performance, mount the roof-mount antenna in the center of the racecar roof. Drill a 3/4" hole in the roof of the racecar and install as shown in the diagram in your instructions. If the racecar roof is ﬁberglass or a non-metal composite material, we suggest ﬁrst mounting an 18" x 18" metal plate or our K-67 Ground Plane Kit under the roof and mounting the antenna to the plate and roof.
PAGE 5
TIPS FOR THE DRIVER: Foam Earmolds: Compress foam evenly and insert into ear. Allow the foam to expand before putting on helmet. Hint: Hook wire over your ear from front to back to keep the earpieces in your ears better. Custom Earmolds: Lightly moisten the earmold for lubrication and they will go in the ear easier. The red earmold is for the right ear. Mic and Helmet Kit: For the noise-cancelling Mic to be effective it must be within 1/4" of your lips.
PAGE 6
MOTOROLA RECHARGEABLE BATTERY - CARE & TIPS: Charge your new battery overnight (14-16 hours) before using it. New batteries can be stored up to two years without signiﬁcant cycle loss. Store new/unused batteries in a cool dry area at room temperature (72 degrees F). Batteries, which have been in storage, should be charged overnight before use. When using a Motorola Rapid Charger, leave the battery in the charger for an additional 1 hour after the green light appears.