User`s manual

12
Definitions for illuminated LED indicators
Power
On
AVR
Using
Battery
Circuit
Breaker
Alarm
Condition
On Off Off Set Off Normal
On
Slow
flash
Off Set Off
AVR- Max. boost 13% of input voltage for
output regulation while input voltage is
from 8% to 15% undernominal.
On
Rapid
flash
Off Set Off
AVR- Max. boost 26% of input voltage for
output regulation while input voltage is
from 15% to 26% under nominal.
Off Off On Set
Two
beeps
AVR- Max. buck 13% of input voltage for
output regulation while input voltage is
from 8% to 26% over nominal.
Off Off On Set
Rapid
beeps
Utility Failure- The UPS is providing
battery power to the Battery backup
outlets.
On/off
On/off/
flash
On/off Set
Long
beeps
Utility Failure- The UPS is providing
battery power. Rapid beeps indicate the
battery will run out of charge within a few
minutes.
Off Off On Up
Long
beep
Overload- Turn the UPS off and unplug at
least one piece of equipment from the
UPS. Wait 5 seconds, reset the circuit
breaker and restart the UPS.
Off Off On Up
Long
beep
Overload- Turn the UPS off and unplug at
least one piece of equipment from the
UPS. Wait 5 seconds, reset the circuit
breaker and restart the UPS.
Off Off Off Set off
Surge Protection Malfunction- Power
surge has damaged the unit. Please
contact CyberPower.