Installation Manual

ManualsBrandsRackUp ManualsCookwareRack It Up 22" Wall Rack Utensil Bar with 8 hooks,Steel Gray Hammertone

Uts B

Mod MPU 13

IMPORTANT!

We are committed to the highest quality in the manufacture of this RACK IT UP! pot rack. The components of

each rack are carefully inspected before shipment.

However, in case there is a problem, PLEASE LET US HELP YOU FIRST. Do not return the item to where you

purchased it. First, call us and explain what is missing or wrong. We will do our best to help with any question

or problem you have—and as fast as possible.

Call us TOLL FREE 1 (877) 362-5863 and ask for customer service. Thank you!

TOOLS NEEDED - We provide all tools required for assembly: hex wrench, fastener hardware (nuts, bolts).

Note under attaching instructions on page 3 of this booklet, the list of tools you will need to provide.

RACK IT UP! 5-Year Limited Warranty

This product is warranted to be free of material defects for a period of five years from the date of purchase. Your exclusive

remedy is the repair or replacement of the defective product, and shall be subject to the following conditions: (1) You send

a notice of any defect to Enclume within the warranty period, and (2) You return the defective product, to Enclume

Design Products, Inc., 24 Colwell Street, Port Hadlock, WA 98339, postage prepaid, within 20 days following receiving a

return authorization number. (A return authorization number may be obtained from Enclume by calling the number at the

bottom of this booklet.) There are no other warranties expressed or implied. There are no warranties of merchantability or

fitness for a particular purpose. Enclume specifically disclaims any and all incidental or consequential damages arising out

of purchase, installation or use of this product.

RACK IT UP! ™ is a trademark of Enclume Design Products.

Summary of content (4 pages)

PAGE 1
Utensil Bar Model MPU 13 IMPORTANT! We are committed to the highest quality in the manufacture of this RACK IT UP! pot rack. The components of each rack are carefully inspected before shipment. However, in case there is a problem, PLEASE LET US HELP YOU FIRST. Do not return the item to where you purchased it. First, call us and explain what is missing or wrong. We will do our best to help with any question or problem you have—and as fast as possible.
PAGE 2
How To Attach Utensil Bar to Wall TIP! FIRST, REMOVE PAINT FROM BOLT HOLES. Because the powder coat finish applied at the factory also adheres to the inside of bolt holes, pushing a bolt through it during assembly may be difficult. Therefore, before connecting parts, we recommend that you check to see that bolts slip easily through all holes. If they do not, carefully clear paint from holes in side bars, ends and arms using a small knife.
PAGE 3
Paintable: Want a different color? The finish on this pot rack can be spray painted any color. We recommend Rustoleum “Hammered” colors for their metal-like finishes, however any quality spray-can paint may be used. See a paint retailer for guidance. Tools Needed: Provided: Installation wall anchors, bolts and hex wrench. You will need: level, tape measure, pencil, drill and 1/8” drill bit, hammer and nail STEP 1: Location Decide where you want to place your utensil bar.
PAGE 4
Installation of Drywall Anchors TOGGLER® brand SNAPTOGGLE® Toggle Bolt Installation Instructions IMPORTANT! If your house is older (maybe a Victorian?) with lath board plaster ceilings and walls, DO NOT use the new drywall anchor system. Old lath board plaster walls are not strong enough to hold drywall anchors. In this case, you must attach the wall rack to wood studs with wood lag screws (not included with your rack). 1) Using an electric drill with ½” bit, drill a hole at each of your marked points .