User's Manual
Table Of Contents
- RAy2 Microwave Link
- Table of Contents
- Important Notice
- Quick guide
- List of documentation
- 1. RAy2 – Microwave Link
- 2. Implementation Notes
- 3. Product
- 4. Accessories
- 5. Step-by-step Guide
- 6. Installation
- 7. Configuration
- 8. Command Line Interface
- 9. Troubleshooting
- 10. Technical parameters
- 11. Safety, environment, licensing
- Appendix A. Antenna dimensions
- Appendix B. Rain zone map
- Appendix C. IP address in the PC (Windows XP)
- Appendix D. IP address in the PC (Windows 7)
- Appendix E. IP address in the PC (Windows 8)
- Appendix F. SSH key generation
- Appendix G. Https certificate
- Appendix H. Unit block diagrams
- Index
- Appendix I. Revision History
The hash computed for address table lookups is used for the Trunk-
Mask selection. Use this parameter to reach better load balancing
between the ports in the trunk.
hash
Port name
Identification of the internal switch port. The switch ports are connected to an external
port or to an internal device (radio modem, management CPU).
The external port (with RJ45 interface) labeled "ETH1+POE". Port 2.
The external port (with SFP interface) labeled "ETH2". Port 4.
The internal port to management CPU. It is physical port number 5.
The internal port to radio modem, i.e. link to the peer unit. Port 6.
Eth1
Eth2
CPU
Air
Enabled
When this parameter is enabled, the port is considered to be a member of a trunk with
the Trunk Id defined below.
Trunk Id
This parameter defines which trunk the port is to be associated with. All ports that are
members of the same trunk must be assigned the same Trunk ID.
Balancing
Trunk Mask bits.
141© RACOM s.r.o. – RAy2 Microwave Link
Configuration