User's Manual
Table Of Contents
- RAy2 Microwave Link
- Table of Contents
- Important Notice
- Quick guide
- List of documentation
- 1. RAy2 – Microwave Link
- 2. Implementation Notes
- 3. Product
- 4. Accessories
- 5. Step-by-step Guide
- 6. Installation
- 7. Configuration
- 8. Command Line Interface
- 9. Troubleshooting
- 10. Technical parameters
- 11. Safety, environment, licensing
- Appendix A. Antenna dimensions
- Appendix B. Rain zone map
- Appendix C. IP address in the PC (Windows XP)
- Appendix D. IP address in the PC (Windows 7)
- Appendix E. IP address in the PC (Windows 8)
- Appendix F. SSH key generation
- Appendix G. Https certificate
- Appendix H. Unit block diagrams
- Index
- Appendix I. Revision History
Firmware upload
Open file upload - opens a dialog for uploading firmware package to the unit buffer.
Only after firmware has been prepared in the buffer, can you perform the actual
upgrade.
NOTE: Use the file as it is (do not unpack).
File name
Name of the uploaded firmware file.
File size [B]
Size of the uploaded firmware file.
Version in buffer
Information about firmware version prepared in the buffer for installation into the
unit (Local, Peer). This firmware must first be prepared in the Firmware upload
section (see above).
Clean buffer
You can use the Clean buffer button to delete prepared firmware package in the
buffer.
Force upgrade
Force mode blocks all safety and compatibility checks and probably bricks your
unit.
You should not use force mode until instructed to do so by the technical support.
Upgrade
Use the Upgrade button to perform the firmware installation.
Warning
Installing the firmware takes several minutes (about 3 minutes). During
this time, transmission of user data is interrupted. Do not interrupt the
power supply during firmware installation!
147© RACOM s.r.o. – RAy2 Microwave Link
Configuration