User's Manual
Table Of Contents
- RAy2 Microwave Link
- Table of Contents
- Important Notice
- Quick guide
- List of documentation
- 1. RAy2 – Microwave Link
- 2. Implementation Notes
- 3. Product
- 4. Accessories
- 5. Step-by-step Guide
- 6. Installation
- 7. Configuration
- 8. Command Line Interface
- 9. Troubleshooting
- 10. Technical parameters
- 11. Safety, environment, licensing
- Appendix A. Antenna dimensions
- Appendix B. Rain zone map
- Appendix C. IP address in the PC (Windows XP)
- Appendix D. IP address in the PC (Windows 7)
- Appendix E. IP address in the PC (Windows 8)
- Appendix F. SSH key generation
- Appendix G. Https certificate
- Appendix H. Unit block diagrams
- Index
- Appendix I. Revision History
Frequency spectrum analyzer
Fig. 7.50: Menu Tools - Frequency analyzer
A very useful tool for identifying in-band interference and locating a free channel. It is not a full-blown
spectrum analyzer as it scans the spectrum with 7MHz channel resolution. The accuracy of measured
results is given by the accuracy of measuring RSS.
Warning
Running spectrum measurement causes interruption of user data flow between stations!
Enable
Opening analyzer functions.
Start
Interrupts communication on the link and starts scanning frequencies in the band.
Spectrum
measure time
Selection of measurement length in range:
single sweep … up to 15 min
Mute peer TX
The deactivation of Peer station transmission during measurement.
After using the analyzer visit any of the Link menu settings and select Refresh. This restores the con-
figuration connection (message Peer: n/a ).
RAy2 Microwave Link – © RACOM s.r.o.152
Configuration