User's Manual
Table Of Contents
- RAy2 Microwave Link
- Table of Contents
- Important Notice
- Quick guide
- List of documentation
- 1. RAy2 – Microwave Link
- 2. Implementation Notes
- 3. Product
- 4. Accessories
- 5. Step-by-step Guide
- 6. Installation
- 7. Configuration
- 8. Command Line Interface
- 9. Troubleshooting
- 10. Technical parameters
- 11. Safety, environment, licensing
- Appendix A. Antenna dimensions
- Appendix B. Rain zone map
- Appendix C. IP address in the PC (Windows XP)
- Appendix D. IP address in the PC (Windows 7)
- Appendix E. IP address in the PC (Windows 8)
- Appendix F. SSH key generation
- Appendix G. Https certificate
- Appendix H. Unit block diagrams
- Index
- Appendix I. Revision History
Appendix D. IP address in the PC (Windows 7)
Setting up the IP address in the PC
For configuration of the link a suitable IP address has to be set up in the PC, for example
192.168.169.160
• Open the Start menu, Control Panel
• In new window choose Network and Internet
• Continue View network status and tasks
• In new window choose Change adapter settings:
• In the Network Connections window, right-click on Local area connection and then left-click on
Properties:
• Select Internet Protocol Version 4 (TCP/IPv4) and Properties
• On the General tab select Use the following IP address
○ Enter IP Address 192.168.169.160
○ Set Subnet mask to 255.255.255.0
○ Click OK to acknowledge these settings and close all windows
RAy2 Microwave Link – © RACOM s.r.o.274
IP address in the PC (Windows 7)