User's Manual
Table Of Contents
- RAy2 Microwave Link
- Table of Contents
- Important Notice
- Quick guide
- List of documentation
- 1. RAy2 – Microwave Link
- 2. Implementation Notes
- 3. Product
- 4. Accessories
- 5. Step-by-step Guide
- 6. Installation
- 7. Configuration
- 8. Command Line Interface
- 9. Troubleshooting
- 10. Technical parameters
- 11. Safety, environment, licensing
- Appendix A. Antenna dimensions
- Appendix B. Rain zone map
- Appendix C. IP address in the PC (Windows XP)
- Appendix D. IP address in the PC (Windows 7)
- Appendix E. IP address in the PC (Windows 8)
- Appendix F. SSH key generation
- Appendix G. Https certificate
- Appendix H. Unit block diagrams
- Index
- Appendix I. Revision History
5.1.2. Menu Link - Service access - Services
• IPv4 address – enter a valid IP address to access the drive. The default IP address has to be replaced
with a valid address. Keeping the default address will probably lead to future problems in the network.
• Netmask – enter the network mask.
• Gateway – if necessary, enter a gateway, otherwise leave blank
• Enable access protocols that you are going to need. For security reasons, do not enable more than
is necessary.
• HTTP(S) – allow access to the web interface.
• Telnet – enabling access to the CLI interface using telnet protocol.
• SSH – enabling access to the CLI interface using SSH protocol.
• Management VLAN – Enabling 802.1Q VLAN tag for separation of user and service operations.
• Management VLAN id – Defining 802.1Q VLAN tag for service operations.
Fig. 5.3: Configuration menu Link settings – Service access – Services
39© RACOM s.r.o. – RAy2 Microwave Link
Step-by-step Guide