User's Manual

ManualsBrandsRacom ManualsElectronicsISM Transmitter

Table Of Contents

RAy2 Microwave Link
Table of Contents
Important Notice
Quick guide
List of documentation
1. RAy2 – Microwave Link
2. Implementation Notes
- 2.1. Link calculation
- 2.2. Example of microwave link design
3. Product
- 3.1. Mounting
- 3.2. Connectors
- 3.3. Power supply
- 3.4. Status LEDs
- 3.5. Technical parameters
- 3.6. Dimensions
- 3.7. Ordering codes
4. Accessories
- 4.1. Overview
- 4.2. Details
5. Step-by-step Guide
- 5.1. Service access
- 5.2. Basic link configuration
- 5.3. Link test
6. Installation
- 6.1. Line of sight test
- 6.2. Antenna mounting
- 6.3. Connectors assembly
- 6.4. Grounding
- 6.5. Start up
7. Configuration
- 7.1. Introduction
- 7.2. Status bar
- 7.3. Status
- 7.4. Link settings
- 7.5. Switch settings
- 7.6. Tools
- 7.7. Help
8. Command Line Interface
- 8.1. Connection via CLI
- 8.2. Working with CLI
  - 8.2.1. SSH keys
  - 8.2.2. Scripts
- 8.3. Configuration with CLI
9. Troubleshooting
10. Technical parameters
- 10.1. General parameters
  - 10.1.1. Technical parameters overview
  - 10.1.2. Link speed
- 10.2. Nominal frequency tables description
- 10.3. RAy2-10 parameters
- 10.4. RAy2-11 A,B parameters
- 10.5. RAy2-11 C,D parameters
- 10.6. RAy2-17 parameters
- 10.7. RAy2-18 parameters
- 10.8. RAy2-24 parameters
11. Safety, environment, licensing
- 11.1. Frequency
- 11.2. Safety distance
- 11.3. Professional installation
- 11.4. RoHS and WEEE compliance
- 11.5. Liability for Defects and Safety Instructions
- 11.6. Important Notifications
- 11.7. Warranty
- 11.8. Declaration of Conformity
- 11.9. FCC authorization of transmitters
- 11.10. Country of Origin Declaration
Appendix A. Antenna dimensions
Appendix B. Rain zone map
Appendix C. IP address in the PC (Windows XP)
Appendix D. IP address in the PC (Windows 7)
Appendix E. IP address in the PC (Windows 8)
Appendix F. SSH key generation
Appendix G. Https certificate
Appendix H. Unit block diagrams
Index
Appendix I. Revision History

b. Slide the antenna bracket onto the mast tube and clamp to the mast by tightening the nuts.

Recommendation: Keep the gap between the two saddle plates (part No. 3) as wide as possible,

so the horizontal angle adjustement screw can fit in this gap. The range of horizontal adjustement

is consequently wider. This has a bigger effect when the mast diameter is smaller.

Fig. 6.10: Attaching the bracket to the mast tube Fig. 6.11: Bracket on the mast tube

c. Screw the hanging bolt (part No. 7) into the upper hole of the mounting plate so that the antenna

can be hung on the mounting plate holder. Hang the antenna on it and tighten the lower bolt. (part

No. 8)

Fig. 6.12: Hanging the bolt on the holder

Fig. 6.13: Correct position of the mounting plate

Installation